SONY SA-VE230-WMS230-SS-CN230-V230 free download

File name SA-VE230-WMS230-SS-CN230-V230.pdf

SA-VE230/WMS230/ SS-CN230/V230 SERVICE MANUAL Ver 1.0 2000.2 US Model Canadian Model · The SA-VE230 system consists of one unit of SA-WMS230, one unit SS-CN230 and Photo: SA-WMS230 four units of SS-V230. Photo: SS-V230 Photo: SS-CN230 SPECIFICATIONS AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION : SA-WMS230 Subwoofer System Speaker system Active subwoofer, magnetically shielded Speaker unit Woofer : 16 cm (63/8 in.), cone type Enclosure type Advanded SAW type Continuous RMS power output (8 , 20 - 150 Hz, 0.8 % THD) 50 W Reproduction frequency range 28 Hz - 200 Hz High frequency cut-off frequency 200 Hz Input LINE IN (input pin jack) General Power requirements Power consumptions Dimensions (w/h/d) with 8 loads both channels driven, from 20 - 150 Hz; rated 50 W per channel minimum RMS power, with no more than 0.8% total harmonic distortion from 250 mW to rated output. SS-V230 Front and rear speakers Speaker system Full range, magnetically shielded Speaker units 5 Ч 9 cm (2 Ч 35/8 in.), cone type Enclosure type Bass reflex Rated impedance 8 Power handling capacity Maximum input power: 100 W Sensitivity level 86 dB (1W, 1m) Frequency range 90 Hz - 20,000 Hz Dimensions (w/h/d) Approx. 70 Ч 151 Ч 126 mm (27/8 Ч 6 Ч 5 in.), including front grille Mass Approx. 550 g (1 lb 3 oz) each SS-CN230 Center speaker Speaker system Full range Ч 2, magnetically shielded Speaker units 5 Ч 9 cm (2 Ч 35/8 in.), cone type Enclosure type Bass reflex Rated impedance 8 Power handling capacity Maximum input power: 120 W Sensitivity level 88 dB (1W, 1m) Frequency range 90 Hz - 20,000 Hz Dimensions (w/h/d) Approx. 301 Ч 70 Ч 126 mm (117/8 Ч 27/8 Ч 5 in.), including front grille Mass Approx. 1.1 kg (2 lb 7 oz) Mass 120 V AC, 60 Hz 45 W Approx. 205 Ч 385 Ч 385 mm (81/8 Ч 151/4 Ч 151/4 in.), including front grille Approx. 10.5 kg (23 lb 2 oz) Supplied accessories Foot pads (20) Audio connecting cords (2 phono to 2 phono) (3) Monaural connecting cord (1 phono to 1 phono) (1) Speaker connecting cords, 10 m (32 ft 93/4 in.) (2) Speaker connecting cords, 2.5 m (8 ft 21/2 in.) (3) Design and specifications are subject to change without notice MICRO SATELLITE SYSTEM SAFETY CHECK-OUT After correcting the original service problem, perform the following safety checks before releasing the set to the customer: Check the antenna terminals, metal trim, "metallized" knobs, screws, and all other exposed metal parts for AC leakage. Check leakage as described below. SAFETY-RELATED COMPONENT WARNING!! COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY. LEAKAGE The AC leakage from any exposed metal part to earth ground and from all exposed metal parts to any exposed metal part having a return to chassis, must not exceed 0.5 mA (500 microamperes).