Sony XM1S free download

File name Sony-XM1S caramp.pdf

XM-1S SERVICE MANUAL Ver. 1.0 2006. 11 US Model Canadian Model AEP Model UK Model E Model SPECIFICATIONS AUDIO POWER SPECIFICATIONS (US MODEL) POWER OUTPUT AND TOTAL HARMONIC DISTORTION 290 watts minimum continuous average power into 4 ohms, 20 Hz to 200 Hz with no more than 1.0% total harmonic distortion per Car Audio Ad Hoc Committee standards. Other Specifications Class D Technology Pulse power supply Inputs RCA pin jacks High level input connector Outputs Speaker terminals Through out pin jacks Suitable speaker impedance 2­8 Maximum outputs 600 W (at 4 ) 900 W (at 2 ) Rated outputs (supply voltage at 14.4 V) 290 W RMS (20 ­ 200 Hz, 1.0% THD+N, at 4 ) 500 W RMS (100 Hz, 1.0% THD+N, at 2 ) SN Ratio 65 dBA (Reference 1 W into 4 ) 90 dBA (Reference rated power into 4 ) Frequency response 5 ­ 300 Hz ( +0 dB) ­3 Harmonic distortion 0.1% or less (at 50 Hz, 4 ) Input level adjustment range 0.3 ­ 6.0 V (RCA pin jacks) 6.5 ­ 16.0 V (High level input) Circuit system Subsonic filter Low pass filter Low boost Power requirements Power supply voltage Current drain Dimensions 15 Hz, ­12 dB/oct 50 ­ 300 Hz, ­12 dB/oct 0 ­ 10 dB (40 Hz) 12 V DC car battery (negative ground) 10.5 ­ 16 V at rated output: 55 A (at 2 ) Remote input: 1 mA Approx. 223 Ч 43.5 Ч 196 mm (8 7/8 Ч 1 3/4 Ч 7 3/4 in.) (w/h/d) not incl. projecting parts and controls Approx. 2.3 kg (5 lb. 2 oz.) not incl. accessories Mounting screws (4) High level input cord (1) Mass Supplied accessories Design and specifications are subject to change without notice. MONAURAL POWER AMPLIFIER 9-887-488-01 2006K04-1 © 2006. 11 Sony Corporation eVehicle Division Published by Sony Techno Create Corporation 1 XM-1S UNLEADED SOLDER Boards requiring use of unleaded solder are printed with the lead free mark (LF) indicating the solder contains no lead. (Caution: Some printed circuit boards may not come printed with the lead free mark due to their particular size.) TABLE OF CONTENTS 1. GENERAL Location and Function of Controls ... 3 Connections ... 4 : LEAD FREE MARK Unleaded solder has the following characteristics. · Unleaded solder melts at a temperature about 40°C higher than ordinary solder. Ordinary soldering irons can be used but the iron tip has to be applied to the solder joint for a slightly longer time. Soldering irons using a temperature regulator should be set to about 350°C. Caution: The printed pattern (copper foil) may peel away if the heated tip is applied for too long, so be careful! · Strong viscosity Unleaded solder is more viscous (sticky, less prone to flow) than ordinary solder so use caution not to let solder bridges occur such as on IC pins, etc. · Usable with ordinary solder It is best to use only unleaded solder but unleaded solder may also be added to ordinary solder. 2. DISASSEMBLY 2-1. MAIN Board Section ... 7