McIntosh MC501 free download

File name McIntosh-MC501 pwramp.pdf

POWER AMPLIFIER CONTENTS Performance Specifications ... 2 Notes ... 2 Top and Rear Views ... 3 Section Location ... 4 Block Diagram ... 5 - 6 Interconnection Diagram ... 7 - 8 Driver/Heatsink Schematic and PCB ... 9 - 13 Power Schematic and PCB ... 15 - 16 Input Schematic and PCB ... 17 - 18 Meter/Lighting Schematic and PCB ... 19 - 20 Parts List ... 21 - 24 Exploded View and Parts List ... 25 - 28 Repacking Instructions ... 29 SERVICE MANUAL PERFORMANCE SPECIFICATIONS Power Output Stereo Minimum sine wave continuous average power output is: 500 watts into 2 ohm load 500 watts into 4 ohm load 500 watts into 8 ohm load Output Load Impedance 2, 4 or 8 ohms Rated Power Band 20Hz to 20,000Hz Total Harmonic Distortion Maximum Total Harmonic Distortion at any power level from 250 milliwatts to rated power output is 0.005% Intermodulation Distortion Maximum Intermodulation Distortion if instantaneous peak output per channel does not exceed twice the rated output, for any combination of frequencies from 20Hz to 20,000Hz, with all channels operating is 0.005% Dynamic Headroom 1.8dB Frequency Response +0, -0.25dB from 20Hz to 20,000Hz +0, -3dB from 10Hz to 100,000Hz Sensitivity 2.1 Volts Unbalanced Input 4.2 Volts Balanced Input A-Weighted Signal To Noise Ratio 97dB (124dB below rated output) Input Impedance 10,000 ohms Unbalanced Inputs 20,000 ohms Balanced Inputs Wide Band Damping Factor 100 (8 ohm wideband) Power Requirements 100 Volts, 50/60Hz at 8 amps 110 Volts, 50/60Hz at 7.2 amps 120 Volts, 50/60Hz at 6.6 amps 220 Volts, 50/60Hz at 3.3 amps 230 Volts, 50/60Hz at 3.3 amps 240 Volts, 50/60Hz at 3.3 amps Note: Refer to the rear panel of the MC501 for the correct voltage. Overall Dimensions 17-1/2 inches (44.45cm) W, 9-7/16 inches (23.97cm) H, 14-3/4 inches (37.5cm) D, including clearance for connectors Weight 91.5 pounds (41.6kg) net, 105.5 pounds (48kg) in shipping carton NOTES 1. The heavy notes on the schematic denote the primary signal path. 2. Unless otherwise noted, all voltages indicated on the schematics are measured under the following conditions: a. AC input at 120 volts, 50/60Hz. b. All voltages are +/-10% with respect to ground. A high impedance (10 megaohm) voltmeter must be used. 3. Unless otherwise specified: a. Resistor values are in ohms. b. Capacitor values are microfarads (uF). c. Inductor values are in microhenries (uH). 4. On PC board drawings, Square pad indicates: a. Polarized Capacitors - Positive b. Diodes - Cathode c.