JVC TM-A101G free download

File name JVC TM-A101G S2M1.pdf

TM-A101G SERVICE MANUAL COLOUR VIDEO MONITOR BASIC CHASSIS TM-A101G/E TM-A101G/U S2M1 CONTENTS SPECIFICATIONS OPERATING INSTRUCTIONS (APPENDIX) SAFETY PRECAUTIONS FEATURES SPECIFIC SERVICE INSTRUCTIONS SERVICE ADJUSTMENTS STANDARD CIRCUIT DIAGRAM (APPENDIX) PARTS LIST 1 2 1-1 3 5 6 11 2-1 35 COPYRIGHT © 2001 VICTOR COMPANY OF JAPAN, LTD. No.51921 Dec. 2001 TM-A101G SPECIFICATIONS Item Dimension (W H D) Mass Colour system 222mm 220mm 6.8kg / 15.0lbs PAL / NTSC 3.58 25cm / 9-7/8" measured diagonally Flat-square type 90 deflection, in-line gun trio­dot type (phosphor dot-trio pitch 0.5 mm) 175mm 137mm (W H) / 222mm (Diagonal) 6-15/16" 5-7/16" (W H) / 8-3/4" (Diagonal) (H)15.734 kHz 15.625 kHz (V)59.94 Hz 50Hz Horizontal resolution Colour Temperature Power requirements High Voltage Power consumption Signal input / output VIDEO A VIDEO B AUDIO A AUDIO B REMOTE INPUT REMOTE ASPECT Audio power output Speaker Operation temperature Operation humidity Composite video signal : BNC terminal, 1V(p-p) 75 negative sync 1 bridge-connected output possible with automatic termination Composite video signal : BNC terminal, 1V(p-p) 75 negative sync 1 bridge-connected output possible with automatic termination Monaural, RCA pin, 500mV(rms) High-impedance, 1-bridge-connected output posible Monaural, RCA pin, 500mV(rms) High-impedance, 1-bridge-connected output posible 1 line, RCA pin input 1 line, RCA pin input 1W (Monaural) 8cm round 1, impedance 8 0 40 (32 104 F) (NTSC) (PAL) (NTSC) (PAL) Content 316.3mm / 8-3/4" 8-11/16" 12-1/2" Picture tube Effective screen size Scanning frequency 280TV line or more 6500K ; x = 0.313, y = 0.329 230V AC, 50/60 Hz [TM-A101G/E] 120V AC, 50/60 Hz [TM-A101G/U] 21.0kV 23.0kV 0.43A [TM-A101G/E] 0.61A [TM-A101G/U] 20 80% (non-condensing) Design & specifications are subject to change without notice. 2 No.51921 TM-A101G SAFETY PRECAUTIONS 1. The design of this product contains special hardware, many circuits and components specially for safety purposes. For continued protection, no changes should be made to the original design unless authorized in writing by the manufacturer. Replacement parts must be identical to those used in the original circuits. Service should be performed by qualified personnel only. 2. Alterations of the design or circuitry of the products should not be made. Any design alterations or additions will void the manufacturer's warranty and will further relieve the manufacturer of responsibility for personal injury or property damage resulting therefrom. 3. Many electrical and mechanical parts in the products have special safety-related characteristics. These characteristics are often not evident from visual inspection nor can the protection afforded by them necessarily be obtained by using replacement components rated for higher voltage, wattage, etc. Replacement parts which have these special safety characteristics are identified in the parts list of Service manual. Electrical components having such fe