Fisher & Paykel Several - MW GW etc free download

File name Fisher and Paykel SmartDrive full Service manual.pdf

SMARTDRIVE® WASHING MACHINE 517769 Fisher & Paykel Appliances © 2003 Reprinted July 2004 SPECIFICATIONS Electric Supply Operating Voltage Maximum Current 220/240V AC 50Hz 2.8 amps Wash Motor Electronically commutated direct drive 3 Phase brushless DC Motor. Motor Resistance: Per Winding Phase to Phase Phase 1 1.3 ohms @ 20oC 2.6 ohms @ 20oC Phases 2 to 4 6.1 ohms @ 20oC 12.2 ohms @ 20oC Phases 5 and 6 16 ohms @ 20oC 32 ohms @ 20oC Pump Motor 230V AC 50Hz Thermal cut-out fitted Pump motor resistance: Compreci 26 ohms @ 20oC Selini 33 ohms @ 20oC Water Valves Phases 1 to 4 Phases 5 and 6 Operating pressures 12 volts DC Resistance 15 ohms @ 20oC 24 volts DC Resistance 64 ohms @ 20oC Maximum 1034 kPa (150PSI) Minimum 20 kPa (3 PSI) Thermistor Phase 1 to 4 this part is not serviceable and is mounted within the Motor Control Module. Phases 5 and 6: NTC-type temperature sensor Resistance 10,000 ohms @ 25oC Resistance 12,500 ohms @ 20oC 2 Diverter Valve Operating Voltage Resistance Range 230V between 0.7k and 2.5k, values are dependent on ambient temperature and when it was last actuated. Lid Lock Resistance range 73 ohms +/- 5 ohms Normally low voltage, potentially 230V if harness is grounded on the cabinet. 3 GW / MW / LW MODELS Size Setting It is important to set the size switch setting into the Motor Control Module's memory whenever a replacement Motor Control Module and or IW Display Module is fitted to SmartDrive. Setting the size switch tells the module what size SmartDrive it is in. Failure to do this will result in SmartDrive faulting with fault code 9. Phases 1 to 3 sizes are determined by two switches on the Display Module that are activated by protrusions on the console when the Display Module is fitted. When replacing a Display Module or Motor Control Module, enter the Option Adjustment Mode to set these sizes in EEPROM. To enter Option Adjustment Mode, with the SmartDrive turned on at the wall and with the LEDs off, press and hold the START/PAUSE button, then press the POWER button. To check the size setting of Phases 1 to 3 SmartDrives, use the Diagnostic Mode. Enter Diagnostic Mode. All LEDs will illuminate for 5 seconds. The display will then change to show switch status. If the Short Wash LED is on the size switch is not set, if the Rinse LED is on the size switch is set for a 5/5.5kg SmartDrive, if the Final Rinse LED is on the size switch is set for a 6.5kg SmartDrive, and if the Spin LED is on the size switch is set for a 7.5kg SmartDrive. To set the size switch on Phases 4 to 6 SmartDrives, turn the power on at the power point and off at the console. Press and hold the TEMPERATURE UP button then press the POWER button. SmartDrive will give 4 short beeps and the pattern of LEDs will change. One of the following buttons needs to be pushed to lock the size into memory. · Press WASH TEMP UP button, the Cold LED is on for 5.5kg (560mm wide). · Press WATER LEVEL UP button, the Low Water LED is on for 6.5kg/7.0kg (600mm wide). ·