philips dvp3360 free download

File name svm_for_european_type_v1.3.pdf

DVD Player DVP3310 DVP3350 DVP3380 DVP3360 DVP3354 DVP3360K DVP3310K DVP3358K DVP3388K DVP3310/12 DVP3360/12 DVP3350/12 DVP3380/12 DVP3350/05 DVP3310/05 DVP3360/05 DVP3380/05 DVP3350/58 DVP3310/58 DVP3354/12 DVP3380/58 DVP3360K/51 DVP3388K/51 DVP3310K/51 DVP3358K/51 DVP3360/58 Service Service Manual This simple Service Manual is for " Exchange" Scenario TABLE OF CONTENTS Page Instruction...2-1 Software Upgrade & Version, Region Code Change...3-1 Accessory list...4-1 Revision List...5-1 ©Copyright 2009 Philips Consumer Electronics B.V. Eindhoven, The Netherlands All rights reserved. No part of this publication may be reproduced, stored in aretrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise without the prior permission of Philips. CLASS 1 LASER PRODUCT GB Published by FK - 0908 BU AVM Printed in The Netherlands Subject to modification 3139 785 34753 Version 1.3 PHILIPS 2-1 How to remove the CD manually from the tray 1. Please do as below instruction in case the tray can not be open: I. II. Power off the DVD player. Please gently push the guider and wait until the tray comes out. (Figure1/2) Figure 1: for DVP3310/DVP3380/DVP3310K/DVP3388K. Figure 2: for DVP3350/DVP3360/DVP3354/DVP3360K/DVP3358K. Figure 1 Figure 2 3-1 Software upgrade (for DVP3310/DVP3310K) How to upgrade the software 1) Burn the data onto a blank CD-R or RW disc. 1) 2) A. Procedure for software upgrade: B. Read out the Firmware version to confirm the upgrading Power on the set and Open the tray door. Press <9><6><6>button to check the software information. The software version and other information are display on the TV screen as follows: BE Version: DVP33XX_XX.XX FE Version: XXXX.XXXXXX DSP Version: DSP.XX Region Code: X 1) Power on the set and insert the prepared Upgrade CDR. 2) The set will starts reading disc & response with the following display TV screen: Loading Firmware Upgrade Erase and program. OK 3) Cancel Select OK to start upgrade. Press button to confirm, then screen will display : Firmware Upgrade Programming, Please Wait... Do not Switch the Player Off ! 4) The upgraded disc will automatically out when files coping complete, then take out the disc. 5) About 1 minute later, the tray will automatically close when upgrading complete. Caution: The set must not be power off during upgrading, Otherwise the Main board will be damaged entirely. Region Code Change 1) Power on the set and open the tray door; 2) Press "9" "8" "7" "9" and press the region code number (0-6) on the remote control. Notes: restart after above steps. 3-2 Software upgrade (for DVP3350/DVP3380/DVP3360/DVP3354/DVP3360K/DVP3358K/DVP3388K) Preparation to upgrade software * 1) Start