Hitachi HTA-4000 free download

File name HTA-4000 instructions.pdf

t t ()l N.= ,A ".-._:--...-...- 2ltiit tttT I English See pages 38 through 40 for figures of this unit. - WARNING:TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. IMPORTANT FOR U.K.: WARNING: This apparatus must be earthed' The wires in this mains lead are coloured in accordance with the following code: Blue: markings As the colours of the wires in the maffi^s lead,of this apparatus may not correspond with the coloured the terminals in your pluf proceed as follows: identifying the letter N or coloured The wire i,f,icn is coloured tiLUf ruit be connected to the terminal which is marked with Brown: NEUTRAL LIVE ! ?hlfrf" which is cotoured BROWN must be connecred to the terminalwhich is marked with ther letter L or col- oured RED. please bear in mind the following points when rnstalling the HTA-4000 or HTA-5000. 1, lnstall it in a place free from direct sunlight and heat from a stove, etc. 2. Since the HTA-4000 or HTA-5000 incorpbrates a large power output amplifier, choose a well ventilated, moisturefree place. 3. lnstall the tuner-amplifier on a stable and vibration-free surface. rack, RKG-8000 or LA-V33 is 4. The installarion indicated in Fig. 1,2and3 (page 39) are recommended. As an audio recommended. heat to dissipate. NoTE: Even when using another audio rack, leave spaces around the components to allow the (1) When measuring the power output or listening to program sources with a 4-ohm load impedance, do not drive the Model HTA-400[ or HTA-5000 at full power for a long period of time. there may be a hum, although QI if," tup" deck used may Ue susceptibie to induction fiom the tuner-amplifier and type of tape beck. lf there is a hum. install the tape deck in a location where it will not be this depends on the ,rr""piibl" to the induction. (For instance, place the tape deck on the right of the tuner-ampfifier when viewed from the front.) perfor(3) Do not place the tape deck on the tunerrnplifier since this will impair the tuner-amplifier's and tape deck's mance. \ 1. Turntable and tape deck connections parallel vinyl cord or a thin shieldBe sure to use thick shielded cables with low stray capacitance for connection. lf a may be produced and the high-range frequency characteristics will deteriorate coned cable is used, inductive hum siderably. Therefoie, it is recommended that you use thick, short cables if available' i 2. Protection circuit I [, rs heard within 3-6 sec. lf Set the SPEAKERS switch@to oN and then the PowER switch@to oN. The sou.nd turn the PowER switch the sound is not heard after 3-6 sec. or the protection cireuit startioperation immediately. and whether the speaker terminals or speaker property di; o;;,;"j "t".r. wheiher the speakerg arethe qause conndcted set the POWER switch@to ON again after of the trouble, leads have beenshort-circuited. Then eliminate the powER-switcrr@gioFF. lf the set still does not work, contact the dealer from waiting for about 1b sec. with