Toshiba e-STUDIO163-166-203-206 free download

File name service handbook e-STUDIO163-166-203-206.pdf

SERVICE HANDBOOK e-STUDIO163/166/203/206 MULTIFUNCTIONAL DIGITAL SYSTEMS File No. SHE050005N0 R05092196301-TTEC Ver14_2009-05 Trademarks · · · · · · The official name of Windows 95 is Microsoft Windows 95 Operating System. The official name of Windows 98 is Microsoft Windows 98 Operating System. The official name of Windows Me is Microsoft Windows Millennium Edition Operating System. The official name of Windows 2000 is Microsoft Windows 2000 Operating System. The official name of Windows XP is Microsoft Windows XP Operating System. Microsoft, Windows, Windows NT, Windows Vista and the brand names and product names of other Microsoft products are trademarks or registered trademarks of Microsoft Corporation in the U.S. and/or other countries. Molykote is a registered trademark of Dow Corning Corporation. Other company names and product names in this manual are the trademarks of their respective companies. · · © 2005 - 2009 TOSHIBA TEC CORPORATION All rights reserved Under the copyright laws, this manual cannot be reproduced in any form without prior written permission of TOSHIBA TEC CORPORATION. No patent liability is assumed, however, with respect to the use of the information contained herein. 07/06 GENERAL PRECAUTIONS REGARDING THE SERVICE FOR e-STUDIO163/166/203/206 The installation and service should be done by a qualified service technician. 1) Transportation/Installation - When transporting/installing the equipment, remove the drawer, employ two persons and be sure to hold the positions as shown in the figure. The equipment is quite heavy and weighs approximately 32 kg (70.55 lb), therefore pay full attention when handling it. - Be sure not to hold the movable parts or units when transporting the equipment. Be sure to use a dedicated outlet with AC 110 V / 13.2 A, 115 V or 127 V / 12 A, 220-240 V or 240 V / 8 A for its power source. The equipment must be grounded for safety. Select a suitable place for installation. Avoid excessive heat, high humidity, dust, vibration and direct sunlight. Provide proper ventilation since the equipment emits a slight amount of ozone. To insure adequate working space for the copying operation, keep a minimum clearance of 80 cm (32") on the left, 80 cm (32") on the right and 10 cm (4") on the rear. The equipment shall be installed near the socket outlet and shall be easily accessible. Be sure to fix and plug in the power cable securely after the installation so that no one trips over it. 07/02 2) General Precautions at Service - Be sure to turn the power OFF and unplug the power cable during service (except for the service should be done with the power turned ON). - Unplug the power cable and clean the area around the prongs of the plug and socket outlet once a year or more. A fire may occur when dust lies on this area. - When the parts are disassembled, reassembly is the reverse of disassembly unless otherwise noted in this manual or other related documents. Be careful not to install small parts su