programmer t300 free download

File name T300_Peugeot_Manual.pdf

18 PEUGEOT PEUGEOT MANUAL CONTENTS APPLICATIONS GENERAL OPERATION SPECIAL FUNCTIONS TIPS & HINTS REMOTE CONTROL PROGRAMMING 7 18 APPLICATIONS VEHICLE 106 7 206 306 307 406 YEAR 1997 ON 1997 ON 1997 ON 2001 ON 97-99 SYSTEM IMMO 1 BSI 1 BSI 2 IMMO 1 CPH BSI 1,2 & 3 IMMO1 CPH 1 CPH 2 BSI BSI BSI BSI 1 2 3 4 CABLE ADC110-B ADC110-B ADC110-B ADC110-B ADC100 + ADC120 NEW 406 99 ON ADC110-B 406 COUPE 18 607 806 97 ON IMMO 1 CPH 1 CPH 2 BSI 1 BSI 2 IMMO 1 IMMO 2 CPH BSI 1 IMMO 1 IMMO 2 CPH IMMO 1 IMMO 2 CPH BSI 1 BSI 2 IMMO 1 IMMO 2 ADC110-B 2001 ON 1997 ON ADC110-B ADC110-B 807 EXPERT 2002 ON 1997 ON ADC110-B PARTNER 1997 ON ADC110-B RANCH 1997 ON ADC110-B GENERAL OPERATION INTRODUCTION The Peugeot Immobiliser systems are made up of 3 different types. They all perform various functions, and it is important to understand the basic configuration and the types of systems fitted. IMM­ STANDARD IMMOBILISER This system was the first transponder system fitted to the Peugeot range of vehicles, after the keypad system was phased out. The system is a basic electronic control unit which consists of immobiliser unit, and transponder aerial to pick up the transponder signal code. This system is similar to the GM immobiliser system, and is programmed and diagnosed in much the same way. CPH--PASSENGER COMPARTMENT PROTECTION CONTROL UNIT 7 The next generation of Immobiliser and alarm system produced was the CPH system which controls a number of additional components which further enhances the vehicle protection system. These include central door locking, ultrasonic sensors to name a few. This system is programmed in much the same way, but offers additional functionality on live data and actuators functions. BSI--BODY SYSTEMS INTERFACE This is the latest system, the alarm and immobiliser have now been incorporated into the body control unit, which controls all body units, including wipers, indicators, lights, doors, windows, locks, boot, service interval, horn, etc. Again, with BSI, the immobiliser is part of a complicated system there are many more functions included, on actuators, special functions and live data. 18 SPECIAL FUNCTIONS PROGRAMMING KEYS--IMMOBILISER 1 SYSTEM DIAGNOSTIC MENU ECU IDENTIFICATION FAULT CODES LIVE DATA ACTUATORS SPECIAL FUNCTIONS PRESS ENTER KEY DIAGNOSTIC MENU PROGRAM KEYS 7 Select SPECIAL FUNCTIONS from the Diagnostic Menu using the UP and DOWN arrows. Then press the ENTER key. NOTE : ENSURE ALL DOORS ARE ALL CLOSED WHEN KEY PROGRAMMING IS BEING PERFORMED. Using the UP and DOWN keys select the PROGRAM KEYS option PRESS ENTER KEY SECURITY CODE ____ To enter the security code use the following procedure :Press To select Number & Letter To Erase the previous To ENTER selection. To Finish PIN selection. 18 SECURITY CODE X4YT IS THIS CORRECT OK=ENTER CLEAR=BACK Press selection Press Press INCORRECT ACCESS CODE If incorrect code is entered the screen will display as shown. NOTE : If the code is entered 3 time in