TOSHIBA E STUDIO 120 150 free download

File name DP1210_SMC_EN_0001.pdf

DIGITAL PLAIN PAPER COPIER e-STUDIO120/150 (DP-1210/1510) File No. SME02000600 R02082121000-TTEC Copyright 2002 TOSHIBA TEC CORPORATION Parts marked with " " are important for maintaining the safely of the machine. Be sure to replace these parts with the replacement parts specified to maintain the safety and performance of the machine. This document has been published to be used for after sales service only. The contents are subject to change without notice. GENERAL PRECAUTIONS REGARDING THE INSTALLATION AND SERVICE FOR e-STUDIO120/150 The installation and service should be done by a qualified service technician. 1. Transportation · When transporting/installing the copier, employ one person and be sure to use the positions as indicated below. The copier is fairly heavy and weighs approximately 17 kg (35.3 lb), therefore pay full attention when handling it. 2. Installation · Be sure to use a dedicated outlet with AC 115 or 120V/15A (220V, 230V, 240V/10A) or more for its power source. · The copier must be grounded for safety. Never ground it to a gas pipe or a water pipe. · Select a suitable place for installation. Avoid excessive heat, high humidity, dust, vibration and direct sunlight. · Also provide proper ventilation as the copier emits a slight amount of ozone. · To insure adequate working space for the copying operation, keep a minimum clearance of 10 cm (4") on the left, 10 cm (4") on the right and 20 cm (8") in the rear. 3. Service of Machines Basically, be sure to turn the main switch off and unplug the power cord during service. Be sure not to touch high-temperature sections such as the exposure lamp, the fuser unit, and their periphery. Be sure not to touch high-voltage sections such as the chargers and the high-voltage transformer. Be sure not to touch rotating/operating sections such as gears, belts, pulleys, fans, etc. When servicing the machines with the main switch turned on, be sure not to touch live sections and rotating/operating sections. Avoid exposure to laser radiation. · Use suitable measuring instruments and tools. · Avoid exposure to laser radiation during servicing. - Avoid direct exposure to beam. - Do not insert tools, parts, etc. that are reflective into the path of the laser beam. - Remove all watches, rings, bracelets, etc. that are reflective. · · · · · 4. Main Service Parts for Safety · The breaker, door switch, fuse, thermostat, thermofuse, thermistor, etc. are particularly important for safety. Be sure to handle/install them properly. 5. Cautionary Labels · During servicing, be sure to check the rating plate and the cautionary labels such as "Unplug the power cord during service", "Hot area", "Laser warning label" etc. to see if there is any dirt on their surface and whether they are properly stuck to the copier. 6. Disposition of Consumable Parts/Packing Materials · Regarding the recovery and disposal of the copier, supplies, consumable parts and packing materials, it is recommended to follow the rel