wolksvagen Passat B6 free download

File name Passat_B6_Skyline_lights_DIY.pdf

Passat B6 / 3C Inner Tail Light Install (aka Skyline lights) Updated Jan 30, 2012 Written by angelico. Please contact me on vwvortex if you have questions or see a change that needs to be made. Notes: The more I looked into these lights, the more I found that could be done with them. There are many different wiring options depending on what function you want the lights to perform. This document should apply to the Jetta as well but the size of the LED board is slightly different, and only works with the Euro LED tails, not the halogen North America tails. The Jetta DIY can be found here, (http://www.angelico.ca/files/Rьckleuchtenmodifikation_Jetta_V.pdf) Special thanks to Kevin Dee, Iulian Dinu, passatfan2006, jhtopilko, chadcronin, LeeNouks, mvfdb6wag, and OemPlus. Purchase info: Preassembled lights (both sedan and wagon) can be purchased directly from: Kevin Dee ([email protected]) (http://www.car-led.com/) Can provide lights for Mazda 6 and Mazda 3. Passat Front LED turn signals and DRL lights also available. Uses OSRAM LEDs, the official supplier to Hella and Valeo. Iulian ([email protected]) (http://www.jlstuning.com/) Can provide lights for Jetta, Golf, and more. Passat front LED turn signals also available and other custom LED work. ---Due to difficulty of modifying your own lights, the LED boards are no longer available--- Personally, I recommend buying the lights already assembled because it's a lot of work to install the boards and you can very easily damage your lights. Leave it to the Pros! Page 1 of 19 Passat Skyline Install Section A: Wiring for the inner taillight: The below instructions assume you are not using the factory single rear fog light and have 2 reverse lights. If you have a World car or right-hand drive, some of the settings are different and you may not need to make any VAGCOM (VCDS) changes. Option 1: Use as additional tail lights and brake lights Wire (+) to pin 4 and (-) to pin 1 on outer tail light. For most North American cars this should result in dim with the regular lights and bright when braking. Option 1a: Use as additional tail lights and brake lights (VCDS required) This requires the left reverse light wire at the ECU to be moved into the "rear fog" position. (http://www.angelico.ca/files/gli_rear_fog.pdf). You do not need the Euro switch or the trigger wire installed for this but if you have them and want to use the rear fog, see option 2. See Section B for building a factory look wire harness. Make the following VCDS changes: All settings are in 09-Central Electronics Byte 3, Bit 1, checked, 1 rear fog light (yes, you will actually have 0) Byte 3, Bit 2, checked, 1 reverse light (yes, you will actually have 2) Byte 4, Bit 6, unchecked Byte 10, 15%, rear fog as parking light (or same as your tail lights are set to) Byte 21, Bit 4, checked, rear fog light as brake light If you receive a bulb out indication, uncheck the following bits in VCDS. Byte 19, Bit 3, Cold Diag Rear fog Byte 19, Bit 6, Col