File information: | |
File name: | 03_ST-A10_QIM SPTM-0013 20071005.pdf [preview ST-A10] |
Size: | 626 kB |
Extension: | |
Mfg: | Toshiba |
Model: | ST-A10 🔎 STA10 |
Original: | |
Descr: | Quick Installation Manual |
Group: | Electronics > Office equipment > Cash registers |
Uploaded: | 07-03-2019 |
User: | svuthai |
Multipart: | No multipart |
Information about the files in archive: | ||
Decompress result: | OK | |
Extracted files: | 1 | |
File name 03_ST-A10_QIM SPTM-0013 20071005.pdf TOSHIBA POS TERMINAL ST-A10 SERIES Quick Installation Manual This sheet contains only the quick Installation procedures. Please be sure to read the Owner's Manual in the web site for further information about this POS terminal. Important Information to the User In order to meet Product Safety and EMC legal Requirements, it is advised to socket the power cord, and interface cable in accordance with the following instructions Otherwise these devices need to meet following standards. Interface Cable You are advised to use a shielded (360 degree) interface cable with this product. The shield must be connected to the frame or earth ground connection or earth ground reference at BOTH ends of the cable. If another cable is used than described above you will need to test this cable with the TOSHIBA TEC POS terminal and your system for FCC and CE mark certification. Power Cord For this product a UL listed, detachable power cord is required. When the power supply is mounted on the floor, a power cord with Type SJT marking is required. Outside the US, power cords need to meet the particular country's certification and application requirements. If a power cord is used different from described above you might violate safety certifications which are in force in the country of use. Caution The socket-outlet needs to be installed near the equipment and must be easily accessible. Do not connect the LAN cable wired outside of a building to the LAN port provided on this product directly. The LAN port is intended for indoor connection. If the product is connected to the LAN cable wired outside of a building, be sure to use any communication equipment, such as a router, a hub, or a modem, which is located within the same building as the product is installed. 1 1. APPEARANCE 12-inch display POS terminal 15-inch display POS terminal LED and CONTROL BUTTON DESCRIPTION This is the LED to indicate the power ON/OFF status of the POS terminal. The blue LED is Power LED (Blue) illuminated when the power is ON. The yellow LED is illuminated during the HDD LED (Yellow) access to the hard disk drive. This is the switch to turn the power of the POS Power Switch terminal ON or OFF. This is used to adjust the brightness of the Brightness Control operator's display. 2 2. CONNECTORS CAUTION! The drawer interface connector is exclusively for connecting the drawer. Do not connect a phone line or any other cables than the drawer cable to this connector. Doing so may cause a failure of the phone line and this terminal. 3 Connector De |
Date | User | Rating | Comment |