Samsung Disassembly & Reassembly free download

File name Disassembly & Reassembly.pdf

3. Disassembly and Assembly 3. Disassembly and Assembly This section describes the disassembly and reassembly sequences for this monitor. Warning: As this monitor has parts that are sensitive to static electricity, be careful when handling them. 3-1. Disassembly Caution: 1. Turn the monitor off before beginning the disassembly process. 2. When disassembling the monitor, do not use any metal tools except for the provided jig. 3. Remove the signal cable and the power cord before beginning the disassembly. Description Photo Screws 1. Place monitor face down on cushioned table. Remove Stand, then remove 2 marked screws from the rear cover. Caution : If you do not tilt the stand and use too much force to remove it, the connection pin may break. 2. Remove the cover and the LCD panel using the provided jig on both grooves at the bottom. 3-1 3. Disassembly and Assembly Description Photo Screws 3. Insertaflatscrewdriverintothegrooveandthen lift up and remove the cover. 4. After remove COVER-REAR, then disconnect SPEAKER , FUNCTION wire. 5. Disconnect LVDS cable from panel. 3-2 3. Disassembly and Assembly Description Photo Screws 6. After disconnecting SHIELD-LAMP of left side, disassemble lamp wire between panel and IP Board. 7. Remove 8 marked SCREW of left picture. Disconnect IP board. Reassembly procedures are in the reverse order of disassembly procedures. 8. Remove the LCD panel. 3-3 3. Disassembly and Assembly Description Photo Screws 9. Remove the IR module by tilting the left snap to the right. 10. Remove the LED module by sliding the snap designatedintherightfigurebackwards. 11. Remove the two (2) screws and then remove the holders from the four (4) snaps designated in the rightfigureusingtheprovidedjig. 3-4 3. Disassembly and Assembly Description Photo Screws 12. Remove the two (2) connectors. Caution : Servicing is not supported for the PCB. Assembly 13. The assembly is in the reverse order of the disassembly. 14. Connect the disassembled snap and the LED module again. 15.Fixtheconnectingwirewithfilamenttape Caution : If the wire is damaged when closing the cover, an operating error may occur.