DE`LONGHI disassembly KM001-KM005 free download

File name disassembly KM001-KM005.pdf

Spares - KM001/002/003/502/005/006/007/506 Disassembly & re-assembly instructions DISMANTLING AND RE-ASSEMBLING OF SOVEREIGN - KM001/002/003 AND KM005/006/007 Please pick one of the following: TOP COVER MOTOR LATCH ASSEMBLY SPEED CONTROL PEDESTAL GEARBOX KNOB TOP COVER 1. REMOVE ALL COVERS 2. REMOVE 4 SCREWS AND SPIGOTS (NO.2 POZIDRIVE) Spares - KM001/002/003/502/005/006/007/506 Disassembly & re-assembly instructions 3. REMOVE SPIGOT PLATE (A SMALL FLAT BLADED SCREWDRIVER INSERTED BETWEEN THE PLATE AND THE CASTING CAN BE USED TO EASE OFF THE PLATE AROUND THE HIGH SPEED SPIGOT) 4. REMOVE 3 SCREWS (NO.2 POZIDRIVE) 5. RAISE HEAD 6. REMOVE 2 SCREWS (TX15) Spares - KM001/002/003/502/005/006/007/506 Disassembly & re-assembly instructions 7. LOWER HEAD 8. LIFT OFF TOP COVER FROM HIGH SPEED OUTLET END OF CASTING 9. RE-ASSEMBLY IS THE REVERSE OF STEPS 1-8 EXCEPT TAKE CARE TO AVOID DISTURBING ANTI-VIBRATION CAP ON THE GEARBOX. Click here to return to the top of the page. PEDESTAL Spares - KM001/002/003/502/005/006/007/506 Disassembly & re-assembly instructions 1. REMOVE ALL COVERS 2. INVERT THE APPLIANCE 3. REMOVE 2 STUFFER BOX SCREWS (TX15 OR TX20) 4. UNCLIP AND REMOVE LID 5. REMOVE 2 FIXING SCREWS (TX20) 6. REMOVE BOX (HANDY AS SCREW TRAY AT THIS POINT) Spares - KM001/002/003/502/005/006/007/506 Disassembly & re-assembly instructions 7. REMOVE CABLE CLAMP SCREW (TX20) 8. REMOVE CABLE CLAMP 9. CAREFULLY OPERATE THE HEAD RELEASE WHILE RESTRAINING THE PEDESTAL. ALLOW TO FULLY OPEN SLOWLY. WARNING: THE PEDESTAL WILL SPRING UP VIOLENTLY UNLESS IT IS RESTRAINED 10. REMOVE 4 SCREWS (TX20) (NOTE - ONE REAR SCREW MAY BE CHANGED TO TX15 ON LATER PRODUCTION) TAKE CARE TO AVOID SCRATCHING BODY WITH THE HEAD LIFT MECHANISM 11. REMOVE LOCATION PIN (8MM HEX NUT) Spares - KM001/002/003/502/005/006/007/506 Disassembly & re-assembly instructions 12. LIFT QUADRANT COVER AND DISCONNECT 3 CONNECTORS (SENSORS, MOTOR SUPPLY, POWER SUP