seg ct1900 free download

File name Monitor.pdf

IMPORTANT SAFETY INSTRUCTION For your protection, please read and observe all safety instructions before operating this receiver and keep this sheet and any additional instructions for future reference. INSTALLATION OBSERVE WARNINGS: All warnings in the operating instructions should be carefully followed. WATER AND MOISTURE: Do not use or install this equipment near water. Severe electrical shock, personal injury or damage to the equipment may result. Operations Manual MiniLink® 5.8 GHz System HEAT: Do not install the equipment near heat sources such as radiators, stoves, heat registers and other appliances that produce heat. CARE & USE POWER SOURCE: Connect the equipment to a power source only of the type described on the operating instructions or as marked on the equipment. ATTACHMENTS: Use only MicroTek recommended attachments. WHEN NOT IN USE: Unplug the power if the equipment is left unattended or unused for long periods of time or during lightning storms REPLACEMENT PARTS: When replacement parts are required, use only replacement parts specified by the manufacturer or that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electrical shock or other hazards and will void the warranty. FCC NOTICE This equipment has been tested and found to comply with the limits of a Class B device, pursuant to PART 15C of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult your dealer or an experienced radio/RF technician for help. Microtek Electronics, Inc. P.O. Box 3464, San Clemente, CA 92673 Information Hotline 888-36-MICRO www.microtekelectronics.com Any changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment. INDEX SECTION QUICK START GUIDE RECEIVER DESCRIPTION -----------------------------FRONT PANEL ----------------------------------------------REAR PANEL ------------------------------------------------REMOTE CONTROL ---------------------------------------WIRING DIAGRAM ----------------------------------------RECEIVER OPERATION --------------------------------HOW TO PROGRAM NEW CHANNELS --------------REMOTE CONTROL KEY OPERATION ------