File information: | |
File name: | Hitachi_42PD380TA_[SM].pdf [preview Hitachi 42PD380TA [SM]] |
Size: | 2036 kB |
Extension: | |
Mfg: | Hitachi |
Model: | Hitachi 42PD380TA [SM] 🔎 |
Original: | Hitachi 42PD380TA [SM] 🔎 |
Descr: | Hitachi Monitor Hitachi_42PD380TA_[SM].pdf |
Group: | Electronics > Computer equipment > Monitors |
Uploaded: | 29-02-2020 |
User: | Anonymous |
Multipart: | No multipart |
Information about the files in archive: | ||
Decompress result: | OK | |
Extracted files: | 1 | |
File name Hitachi_42PD380TA_[SM].pdf 42PD380TA SERVICE MANUAL 42" PLASMA COLOR TELEVISION ORIGINAL MFR'S VERSION A Design and specifications are subject to change without notice. SERVICING NOTICES ON CHECKING 1. KEEP THE NOTICES 11.When you remove the cover, do not scratch the FPC on both ends of PDP Module. As for the places which need special attentions, 12.Hold the four ends holder and be careful not to they are indicated with the labels or seals on the touch the glass area. cabinet, chassis and parts. Make sure to keep the 13.Take care for the damage of vacuum exhaust indications and notices in the operation manual. pipe due to a collision. 2. AVOID AN ELECTRIC SHOCK 14.Moisture condensation may damage the PDP There is a high voltage part inside. Avoid an Module. electric shock while the electric current is So, leave it for 48 hours at the service room. flowing. 5. PUT PARTS AND WIRES IN THE 3. USE THE DESIGNATED PARTS ORIGINAL POSITION AFTER The parts in this equipment have the specific ASSEMBLING OR WIRING characters of incombustibility and withstand There are parts which use the insulation voltage for safety. Therefore, the part which is material such as a tube or tape for safety, or replaced should be used the part which has which are assembled in the condition that the same character. these do not contact with the printed board. Especially as to the important parts for safety The inside wiring is designed not to get closer which is indicated in the circuit diagram or the to the pyrogenic parts and high voltage parts. table of parts as a mark, the designated Therefore, put these parts in the original parts must be used. positions. 4. BE CAREFUL WITH THE PDP PANEL 6. PERFORM A SAFETY CHECK AFTER 1. When you handle the PDP Filter you must SERVICING wear the gloves twice, because, you are to Confirm that the screws, parts and wiring which avoid soil it by your sweat and dust. were removed in order to service are put in the 2. When you lift the PDP Filter you should hold it original positions, or whether there are the |
Date | User | Rating | Comment |