HP 27128-90001 27128A Asynchronous Serial Interface Installation Sep82 free download

File name 27128-90001_27128A_Asynchronous_Serial_Interface_Installation_Sep82.pdf

Flin- HEWLETT a:~ PACKARD HP 27128A Asynchronous Serial Interface (ASI) Installation Manual Card Assembly: 27128-60001 Date Code: A-2218 Manual Part Number 27128-90001 Printing History First Edition ... September 1982 Notice The information contained in this document is subject to change without notice. HEWLETT-PACKARD MAKES NO WARRANTY OF ANY KIND WITH REGARD TO THIS MATERIAL, INCLUDING, BUT NOT LI- MITED TO, THE IMPLIED WARRANTIES OF MERCHANTABIL- ITY AND FITNESS FOR A PARTICULAR PURPOSE. Hewlett- Packard shall not be liable for errors contained herein or for inciden- tal or consequential damages in connection with the furnishing, per- formance, or use of this manual. This document contains proprietary information which is protected by copyright. All rights are reserved. No part of this document may be photocopied or reproduced without the prior written consent of Hewlett-Packard Company. This manual provides information for you to install and verify correct operation of the HP 27128A Asynchronous Serial Interface (ASI) card. You will also need the appropriate computer system installation manual. These two manuals should provide all the required information. If your installation is such that you need additional information concerning the ASI card, order the HP 27132A Technical Reference Package from the nearest Hewlett-Packard Sales and Service Office. Installation and Checkout To install and check the operation of the ASI card, follow the steps below in the order given: 1. Deterrnine if your computer system can supply the power needed for the ASI card. Refer to table 1 for power requirements. 2. Set the switches on the card for proper operation in your system. Refer to tables 2 and 3 for switch information. 3. Install the card in the appropriate slot in the computer. Refer to the computer system installation manual to determine the correct slot. 4. Connect the cable, supplied with the card, from J2 on the card to the peripheral device. If you have the diagnostic test hood, which exercises slightly more of the card's circuitry, and can be ordered (Hewlett Packard part number 1258-0207), connect it to J2 instead of connecting the cable. 5. Turn on computer system power.