Samsung Samsung BN44-00124D [SCH] free download

File name Samsung_BN44-00124D_[SCH].pdf

13 Circuit Descriptions 13 Circuit Descriptions 13-1 Overall Block Structure 13-1-1 Power Tree AP1084 ~ 3.3 1. When the AD board is in DPMS state: 1.1 The IP has been designed so that it operates with a power consumption of less than 0.6W of. 1.2 The Scaler consumes power up to 37mA 1.3 The power to the panel is switched off 2. When the AD board is operating normally: 2.1 The maximum power consumption of the panel lamps is described below (It may vary depending on the panel manufacturer) 17" : 4*(7.5mA*650mVrms)=4*4.9=19.6W 19: : 4*(7.5mA*720mVrms)=4*5.4=21.6W 2.2 The power consumption of the Panel Control board is as follows: 5V*720mA=3.6W 2.3 The power consumption of the Scaler is as follows: 3.3V*245mA + 1.8V*300mA = 1.35W 13-1 13 Circuit Descriptions 13-1-2 Main Board Parts SCALER GM5726-LF 1. Inverter: A conversion device that converts DC 6. Scaler & EEPROM: I2C is a two-way serial bus rated voltage/current to high ones necessary of two lines that supports communications for the panel lamp. across the integrated circuits as well as between FLASH and EEPROM. 2. DC/DC(Regulator): General term for DC to DC In particular, MCU(SE657MRH-LF) and use the converting devices. SDR direct bus for mutual communications, The IP board receives 5V and outputs 1.8 or which is an effective, speedy system because it 3.3V that is supplied to the scaler allows 4 additional address/data lines com- (SE657MRH-LF). pared to the old serial systems. 3. Power MosFET: The IP board receives 5V and 7. Function Key: A certain keystroke generates a outputs a lower voltage in DPMS mode and certain electrical potential, which is transferred supplies the whole 5V for the panel operating into ADC input port of the MCU and then con- board in normal conditions. In that case, the verted to a digital value by the A/D converter of switching of Power MosFET is controlled by the chip. The digital value (data) is a clue to Micom. which key is entered. In practical, the voltage levels are set as below. 4. Scaler: Receives the digital TMDS and analog R,G,B signals and convert them to proper reso- lutions using up- or down- scaling that are transferred to the panel in the LDVS formats. 5. Crystal(Oscillator): Use one 14.318MHz oscillator externally to supply power to both MCU and Scaler at the