Samsung Samsung chassis K15D[1].part1 free download

File name Samsung chassis K15D[1].part1.rar

Alignment and Adjustments 4. Alignment and Adjustments 4-1 Preadjustment 4-1-1 Factory Mode 4-1-3 When CRT Is Replaced 1. Do not attempt these adjustments in the Video 1. Make the following adjustments AFTER set- Mode. ting up after setting up purity and conver- gence : 2. The Factory Mode adjustments are necessary when either the EEPROM (IC902) or the CRT White Balance is replaced. Sub-Brightness Vertical Center 3. Do not tamper with the "Adjustment" screen Vertical Size of the Factory Mode menu. This screen is Horizontal Size intended only for factory use. Fail Safe (This adjustment must be the last step). 4-1-2 When EEPROM (IC902) Is Replaced 2. If the EEPROM or CRT is replaced and set SC 1. When IC902 is replaced all adjustment data as 20(factory mode). revert to initial values. It is necessary to re-program this data. 2. After IC902 is replaced, warm up the TV for 10 seconds. 4-2 Factory/Service Mode 4-2-1 Procedure for the "Adjustment" Mode 1. This mode uses the standard remote control. 4. Selection sequences for the all system: The Service Mode is activated by entering the following remote-control sequence : DOWN or UP key: (1) DISPLAY FACTORY. SCT>SBT>BLR>BLB>RG>GG>BG>VSL>VS> VA>HS>SC>CDL>STT>AKB>FS>NDL> (2) STAND-BY MUTE 1 8 2 LBS>NSR>SCBT>VOL>CAP>HBS>RP00> POWER ON. RP01>FMWS>AGC1>OMD>SCL>PWL> MUS>AGC>DSK>DVDB 2. The "SERVICE (FACTORY)" message will be displayed. The Service Mode has four compo- 5. The VOLUME keys increase or decrease the nents: ADJUST, OPTION , G2-ADJUST and adjustment values (stored in the RESET. non-volatile memory) when Adjustment Mode is cancelled. 3. Access the Adjustment Mode by pressing the "VOLUME" keys ( Up or Down). The adjust- 6. Cancel the Adjustment Mode by re-pressing ment parameters are listed in the accompany- the "FACTORY" or "Power OFF" keys. ing table, and selected by pressing the CHAN- NEL keys ( , ). Samsung Electronics 4-1 Alignment and Adjustments 4-2-2 Main Adjustment Parameter SETTING NO OSD