| Subject | Text |
| SA AK 40 | Excuse me if my question is a little bit strange, but can I re-make a Panasonic SA AK 40 to play MP |
| Philips 22dc670 operating manual | Hallo folks,
I just bought a Kadett from 1991 in good condition but with a bad battery. I have my |
|
|
| Just had my repaired this morning $375 | Hi,
It was a simple soldering job.
A little bit of a pain to get to. He did say to put plenty |
| Plasma colours odd until it warms up | I have had what sounds like the same issue. I haven't had an LCD I couldn't repair yet, however I'm |
| Vertical Lines | species8472, i think this was more luck than judgement. The vertical line is caused by 1 of 2 reason |
| here is the color codes:
PIN LABEL FUNCTION COLOR
1 RED Red color signal pink
2 GREEN Green co |
| tv block diagram | This is a bit oversimplified, but....
:[url]http://electronics.howstuffworks.com/tv3.htm[/url] |
| Sony KVX-2552U | Just wanted to add a little bit to the repair tip for this model. I read the tip for intermittent co |
| HeVi, many thanks for the advice but could you please... | Hi, HeVi,
Many thanks for the advice but could you please clarify...
I'm sorry but I'm a bit thi |
| reply | The problem is the tube. Set the G2 a little bit lower. The lines will disappear. |
| Anything is possible. A bit involved depending on your application.. I used to make PCB's and if you |
| Re: GoodmansGTV 69W | [quote:98ccbc9cc5="pauldk"]Thanks for replying atom, yeah apparently goodmans "supply" a range of TV |
| It's unfortunate and expensive that all have blown :(
Which ones have blown? Have a set of the 2S |
| [quote:6a60d01696="Anonymous"]It's most definitely a connection problem in the filament circuit for |
| Re: RCA Projection TV Convergence - P46150WK | [quote:2ced87731d="RCAOwner"]Hello and Happy Holidays. Hoping someone can assist me with a repair o |
| RGB adjust or ServiceBook-Sony KV-28FX20B Wide Screen TV | I just got a somewhat used Sony KV-28FX20B 16x9 TV.
It has 2 scart connections that handle several |
| I'll always dip new tips in a bit of solder. So the tip gets a protective coating.
Also, when cle |
|
|
| Manual for Bush 2876NTX anyone? | Hi, I have just bought the remote for the Bush 2876NTX but I can't tune the channels in. I can't see |
| 8255 is rather old, but it is cheap and has 3 x 8 I/O ports.
There is a lot written about this IC.
|
| Big screen tv's,in general. | I thought i hit a GOLD MINE one day-I looked outside in the a.m.,thought i was hallucinating...but n |
| Ha. I guess, since I know very little of these problems, I have started a bit vague. I can tell yo |
| soldering always getting a dull finish, dry ? | hi,
i bought a soldering atation and doing a bit of soldering work on a curcuit board,\
howeve |
| Proview 998A.rar | Proview 998A.rar
0 bit :shock: |
| thanks! | thanks, walter58 for your advice. sounds like you know your stuff! misfortunately, this is the diagn |
| Same problem: Pioneer SD-P5075 - A great TV.. | Our Pioneer SD-P5075 bit the dust.. Turns off immediately on power on sequence. Some chip problem, |
| Pioneer XC-P410T Schematics | Does anyone have schematics / service manual for a Pioneer XC-P410T.
It's quite old c.1991 but I |
| need schematic/service manual | i checked the database first and was not able to locate it so i thought i would post here. i am in |
| How is the set stuck in standby? Are there any sounds coming from the back of the TV when you switch |
| A bit hard to say without going into the actual troubleshooting...
Worst case: your picture tube |
| Mitsubishi VS-5004R Green Screen. I could use some guidance | I have a Mitsubishi Vs-5004R that when powered on the screen is completly green.
I woke up to thi |