Subject | Text |
| When you replace the painter IC on the SSB panel you're going to need to put in all of the service a |
| Hi
just llolol myself out m8
What you neeed to do is get a program like WINRAR to extract the file |
|
APEX 20" COLOR T.V. SET MODEL # AT2002 | MY APEX 20" T.V. SET JUST WILL NOT TURN ON BY PUSHING THE ON BUTTON ON T.V. OR BY USING THE REMOTE. |
monitor | try to resolder the pincusion section even and also if thier is coil and small transformer solder it |
Humax IRCI-5400Z no Power | Help would be verry mutch appreciated.
Wilst watching the SOCCER the unit switched momentary to car |
philips monitor#201B10/00,fcc id:A3KM094 | Hi can anyone tell me where to find a schematic for philips model 201B10/00 20 inches monitor, i nee |
| Mark and Guest,
Your comments are highly appreciated. I think the little spring belongs to the doo |
Datasheets and schematics of Toshiba Satellite 1900 | Hi,
I looking for Datasheets and schematics of Toshiba Satellite 1900,
I need it for repair |
HP930C | I ned to find out how to open a HP930C printer so I can clean the inside of spilt ink. |
27GT730 Television | My TV has no picture and no sound. It is emitting a high pitch sound from inside the unit. Any ide |
| Most appliances have a basic wiring diagram pasted in them somewhere. Look on back, inside covers, e |
Pioneer LD-700 service/user manual needed | I am looking for the service manual of the early LD-700 laserdisc from Pioneer.
The problem is th |
Is this normal appearance for and amplifier IC?? | I'm in uncharted territory (for me, anyway). I'm a radio tech--and don't find much in a CB I can't |
diagram | I have the crt panel-diagram.I can send it to you if you like.
PS : 1)also check the vertical def |
Grunding ghm9100 | Somebody Can help me.
I have got a radio model grunding ghm9100 , when I insert the front panel don |
| "An old one" as jts1957 said and I'll add do it with rubber gloves!!!!!
You don't say w |
| ahhh I think you must adjust your horizontal linearity,its near at the horizontal drive section. If |
|
| If you have no experience in tv-repair, YES you should be very carefull when soldering on the inside |