Text preview for : HDD0x0_Main_Board_exchange.pdf part of Philips HDD0x0 Main Board exchange Philips Symptom Cure 17-04-2004 References HDD0x0_Main_Board_exchange.pdf



Back to : HDD0x0_Main_Board_exchang | Home

PAI
HDD0x0 Main Board exchange
(New)
Power on the device
After powering on the device the Philips logo should be visible on the screen.




Enable harddisk
Press the "Vol-" key together with the "Cursor Right" key

The LCD will now show the following :




and after about 2-5 seconds it should also show HD init'zed. During the initialisation
sequence, backlight of the device will be activated. After the disk start sequence is completed
the backlight will be turned off, and you can proceed to the next step. LCD now shows as
following :



1/8 DE10JUN 09.11.04
PAI




Connect USB cable
After the HD is enabled, connect the USB cable to the PC. Within about 15 seconds it should
show as a drive letter in the windows explorer.




If old files are stored on the disc, delete them or format the disc, to get an empty device.




2/8 DE10JUN 09.11.04
PAI




Once this shows, start the Application_xxx.exe file and extract contend to the device.
Take care that the correct drive letter is typed in. e.g. e:




Unplug the USB device
Press the disconnect icon (in the lower right corner of the screen)




Select the HDD0x0.




3/8 DE10JUN 09.11.04
PAI




Press the stop button, following screen should appear.




Now press OK, following message must appear.




After this message is shown, disconnect the USB cable from the HDD0x0.




4/8 DE10JUN 09.11.04
PAI
Restart the HDD0x0
Reprogramming only HDD050, HDD065 and 070