Text preview for : Sony_DV-PS360_Bulletins_for_DVD_Player.pdf part of sony DVPS360 SCHEMATIC
Back to : Sony_DV-PS360_Bulletins_f | Home
[Sony Service] Technical Services Electronic Service Information Field Problem Reports -----------------------------------------------------------------------FPR Number: Submitted by: Tremble, C. Engineer: TC Model(s): DVPS560D Subject: No part number listed for IC101 Symptom: Last Update: 2001-05-08 Status: Closed Customer Description: Missing Part Number Solution: IC101 Part# 9-885-005-99 Technical Description: No part number is listed for IC1010 in s/m for board SRV940JUC. Schematic is also incorrect in calling IC101 an - ON3131. A ON3131 is an opto isolator. IC101 is drawn as a power control FET type integrated circuit. Part's Information: P/N Description Reference Board Symptom ----------------------------------------------------------------------------------9-885-005-99 SRV940JUC IC101
Sony Service Company National Technical Services A Division of Sony Electronics Inc. Park Ridge, New Jersey 07656
CONFIDENTIAL
Service Bulletin Multi-Disc Players
No.
CSV-5
Model:
DVP-S360, DVP-S560D, DVP-S570D, DVP-C660, DVP-C670D
68
Subject: PLAYER MAY NOT PLAY CD/DVD OR VCD Symptom: (111A) Solution:
Date: September 8, 2000
The DVD player may not play disc. The display may indicate "No Disc "or C:13:00" Please remove fuse F402 and replace with 0-ohm resistor on MB board (side B). Next, exchange resistors R416 and R418. The original values are 150K, change them both to 82K ohms REF F402 R416/ R418 DESCRIPTION CONDUCTOR, CHIP(2012) METL RES 0H 1/10W RESISTOR,CHIP 82K 1/16W PART NUMBER 1-216-295-11 1-216-844-11
There are 2 types of MB-bds depending on model. DVPS360, Dvps560D, DVPS570D (mb-86) DVPC660, DVPC670D is (mb-87)
Reference: HVDK00e007
PRINTED IN USA
Multi-Disc Products Service Bulletin No. 68
. 3. Measure the resistor between Pin # 21 & Pin # 22 of the Flexible Cable, which is connected with the OPT. (See the figure below.) If the resistor between Pin # 21 & Pin # 22 is below 6 ohms, replace the OPT to the new one.
4. Please do servo adjustment,after replacing components and/or optical.