Text preview for : t_mode1.pdf part of panasonic t mode1 panasonic DVD-Video NV-VP33EF MAD0504002CE doc t_mode1.pdf
Back to : t_mode1.pdf | Home
Item Player mode and Function Display Cancellation
button combination method
Jitter check In STOP (no disc) mode, Jitter check Press STOP
press PLAY (DVD) and Jitter rate is measured and J XXX Display 1 or OPEN
OPEN buttons on the displayed. Measurement is Jitter rate button.
player, and "5" button on repeatedly done in the cycle of one Jitter check mode
the remote control unit. second. Read error counter starts
from zero upon mode setting. When Press STATUS Key
target block data failed to be read to select Display 1 or 2
out, the counter advances by one
increment. When the failure is
caused by minor error, it may be
corrected when retried to enable YYY ZZ Display 2
successful reading. In this case, the
counter advances by one. When the Focus drive value
error persists even after retry, the Read error counter
counter may jump by two or more.
Jitter rate is shown in decimal notation to one
place of decimal. Focus drive value is shown in
hexadecimal notation.
Error code In STOP (no disc) mode, Error code check Error code (play_err) is expressed in the Cancelled
check press PLAY (DVD) and The latest error code stored in following convention. automatically
OPEN buttons on the EEPROM is displayed. Error code = 0 x DAXX is expressed: " nn UXX 5 seconds
player, and "0" button on Error code = 0 x DBXX is expressed: " nn HXX later.
the remote control unit.* Error code = 0 x DXXX is expressed: " nn FXXX
With pointing of cursor up Error code = 0 x 0000 is expressed: " nn F---
and down on display, the * "nn" denotes the serial number of history.
panel controller switches
serial number of history
and sends out the
command accordingly.
Initialsetting In STOP (no disc) mode, Initial setting of laser drive current Cancelled
of laser drive press PLAY (DVD) and Initial current value for each of DVD LD0 Display 1 automatically
current OPEN buttons on the laser and CD laser is separately Laser current 5 seconds
player, and PAUSE button saved in EEPROM. measurement mode later.
on the remote control unit.
Press STATUS Key
to select Display 1 or 2
034032 Display 2
CD laser current
measurement
DVD laser current
measurement
The value denotes the current in decimal
notation. The above example shows the initial
current is 34mA and 28mA for DVD laser and CD
laser respectively when the laser is switched on.