Text preview for : c9smtm1.pdf part of panasonic c9smtm1 panasonic Audio SA-PT570EB PSG0901003CE doc c9smtm1.pdf
Back to : c9smtm1.pdf | Home
Item Key Operation
FL Display
Mode Name Description Front Key
Error code Error code check In STOP (no disc) mode,
check The latest error code stored in the press [STOP] button on the
EEPROM IC is displayed. main unit, and [0] button on
the remote control unit. *With
pointing of cursor up and
F/H/U down on display.
Error code (play_err) is expressed in the Cancelled automatically
following convention. 5 seconds later.
Note: Refer to "Section 8.3 DVD Self Error code = 0 x DAXX is expressed: DVDnn U12 To exit, press [POWER]
Diagnostic Function-Error Code" for Error code = 0 x DBXX is expressed: DVDnn H12 button on main unit or
more detailed information on the error Error code = 0 x DXXX is expressed: DVDnn F123 remote control.
codes. Error code = 0 x 0000 is expressed: DVDnn F---
* "xx" denotes the error code
Jitter check Jitter check. (Display 1) In STOP mode, press
Jitter rate is measured and displayed. [STOP] button on the main
Measurement is repeatedly done in unit, and [5] button on
the cycle of one second. Read error the remote control unit.
counter starts from zero upon mode
setting. Press [POWER] or [STOP]
When target block data failed to be Jitter check Jitter rate button to exit.
read out, the counter advances by one mode
increment. When the failure is caused
by minor error, it may be corrected Jitter rate is shown in decimal notation to one
when retried to enable successful place of decimal.
reading. Focus drive value is shown in hexadecimal
In this case, the counter advances by notation.
one. When the error persists even
(Display 2)
after retry, the counter may jump by
two or more. Press [FL Display] on
remote control unit for next
FL Display sequence: page (FL Display).
Display 1 2.
Lead Focus Drive
Error Value
Counter
Initial setting of Initial setting of laser drive current. (Display 1) In STOP (no disc) mode,
laser drive Initial current value for the DVD laser press [STOP] button on the
current and CD laser is separately saved in main unit, and [PAUSE]
the EEPROM IC. button on the remote
control unit.
FL Display sequence: Cancelled automatically
Display 1 2. Laser current 5 seconds later.
measurement
mode
The value denotes the current in decimal
notation.
(Display 2)
Press [FL Display] on
remote control unit for next
page (FL Display) on values
of laser drive current.
CD DVD Laser
Laser
The above example shows the initial current
is XXXmA and YYYmA for CD laser and
DVD laser respectively when the laser is
switched on.