Text preview for : 7jsmtm4.pdf part of panasonic 7jsmtm4 panasonic Audio SA-PTX7EB MD0704019CE doc 7jsmtm4.pdf
Back to : 7jsmtm4.pdf | Home
Item Key Operation
FL Display
Mode Name Description Front Key
Jitter check Jitter check. (Display 1) In STOP (no disc) mode,
Jitter rate is measured and displayed. press [STOP] button on the
Measurement is repeatedly done in main unit, and [5] button on
the cycle of one second. Read error the remote control unit.
counter starts from zero upon mode Press [POWER] button to
setting. exit.
When target block data failed to be Jitter check Jitter rate
read out, the counter advances by one mode
increment. When the failure is caused
by minor error, it may be corrected Jitter rate is shown in decimal notation to
when retried to enable successful one place of decimal.
reading. Focus drive value is shown in hexadecimal
In this case, the counter advances by notation.
one. When the error persists even (Display 2)
after retry, the counter may jump by Press [FL Display] on
two or more. remote control unit for next
page (FL Display).
FL Display sequence:
Display 1 2.
Lead Focus
Error Drive
Counter Value
Region display Region code display, TV broadcasting In STOP (no disc)
system & the model no. information. mode, press [STOP]
button on the main unit,
and [6] button on the
remote control unit.
Model Cancelled automatically
No. 5 seconds later.
Information
N: NTSC / 6: PAL60
Note: Refer to Figure 2 for "Video N: no PAL / P: PAL
Design Information".
Region No.: 0-8
Micro- Micro-processor firmware version (Display 1) In STOP (no disc)
processor display & EEPROM checksum display. mode, press [STOP]
firmware EEPROM checksum is only available button on the main unit,
version display due to existence of EEPROM IC. and [7] button on the
& EEPROM remote control unit.
checksum EEPROM Cancelled automatically
display. Checksum 5 seconds later.
(If applicable,
refer below.)
Error code Error code check In STOP (no disc) mode,
check The latest error code stored in the press [STOP] button on the
EEPROM IC is displayed. main unit, and [0] button on
the remote control unit. * With
pointing of cursor up and
Error Code
down on display.
U/H/F Cancelled automatically
(Error Type) 5 seconds later.
To exit, press [POWER]
Error code (play_err) is expressed in the
Note: Refer to "Section 10.3 DVD Self button on main unit or
following convention.
Diagnostic Function-Error Code" for remote control.
Error code = 0 x DAXX is expressed: DVDnn U12
more detailed information on the error Error code = 0 x DBXX is expressed: DVDnn H12
codes. Error code = 0 x DXXX is expressed: DVDnn F123
Error code = 0 x 0000 is expressed: DVDnn F---
* "xx" denotes the error code