Text preview for : p06.pdf part of Philips p06 Philips Monitor CD 2001 Monitor CD 2001 E-MANUALS Philips crt 109b2 pdf p06.pdf
Back to : p06.pdf | Home
6 109B2 GS3 CM25 OSD Lock Function & Service Mode
Go to cover page
To lock (disable) OSD function: Access Service mode (burn in mode) :
- Press OSD button " " for over 15 seconds to lock the OSD function. Access Service Mode & Burn in mode
Release it, then OSD comes on the screen as below.
Firstly, get into Factory Adjustment Mode.
ATTENTION Push LEFT & RIGHT buttons at the same time for
over 15 seconds and release them.
CONTROL MENU IS LOCKED The factory message appears at the bottom of the
main OSD menu. (for example : 109B2 V1.52 20000619;
00115 is M.T.B.F. in HOUR unit)
00115
To unlock (enable) OSD function:
- Press OSD button " " for over 10 seconds again to unlock the
OSD function.
Release it, then OSD comes on the screen as below.
109B2 V1.52 20000619
Disable/Enable all the WARNING SIGNAL
To disable all the WARNING SIGNAL :
- Disconnect the Interface cable of the monitor.
- Push LEFT & RIGHT buttons at the same time, then power
- Disconnect the Interface cable of the monitor (Monitor is ON.).
ON.
- Press OSD button " " for over 15 seconds to disable all the
WARNING SIGNAL. Then release the "OSD" button.
- If it is successful, the signal " "
- If it is successful, then the signal " NO SIGNAL INPUT "disappeared to
comes on the screen later. SERVICE MODE
enter power saving-off mode. SERIAL NO: TY 123456
(Background is white.).
HOURS : 00021
FACTORY VER 1.01 990706
Exit "burn in MODE" :
- Reconnect the interface cable to PC, then the "burn in MODE"
To enable all the WARNING SIGNAL :
disappear.
- After disconnect the Interface cable of the monitor, then Monitor is
powered ON.
- If it is successful, the signal " NO SIGNAL INPUT " comes on the screen
again later.
Back Forward