Text preview for : Compaq DeskPro EN SM AppB.pdf part of Compaq DeskPro EN Series DeskPro EN Series Service Manual
Back to : DeskPro EN.rar | Home
appendix
B
POWER CORD SET REQUIREMENTS
The voltage select switch feature on the computer permits it to operate from any line voltage between 100-120 or 220-240 volts AC. The power cord set received with the computer meets the requirements for use in the country where you purchased the equipment. Power cord sets for use in other countries must meet the requirements of the country where you use the computer. For more information on power cord set requirements, contact your authorized Compaq dealer, reseller, or service provider.
General Requirements
The requirements listed below are applicable to all countries: 1. The length of the power cord set must be at least 6.00 feet (1.8 m) and a maximum of 9.75 feet (3.0 m). 2. All power cord sets must be approved by an acceptable accredited agency responsible for evaluation in the country where the power cord set will be used. 3. The power cord set must have a minimum current capacity of 10A and a nominal voltage rating of 125 or 250 volts AC, as required by each country's power system. 4. The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320 Standard Sheet C13 connector, for mating with appliance inlet on the Switch Box.
Compaq Deskpro EN Series of Personal Computers
B-1
Country-Specific Requirements
Additional requirements specific to a country are shown in parentheses and explained below.
Country
Australia (1) Austria (1) Belgium (1) Canada (2) Denmark (1) Finland (1) France (1) Germany (1) Notes: (1) The flexible cord must be Type HO5VV-F, 3-conductor, 1.0 mm2 conductor size. Power cord set fittings (appliance coupler and wall plug) must bear the certification mark of the agency responsible for evaluation in the country where it will be used. (2) The flexible cord must be Type SJT or equivalent, No. 18 AWG, 3-conductor. The wall plug must be a two-pole grounding type with a NEMA 5-15P (15A, 125V) or NEMA 6-15P (15A 250V) configuration. (3) The appliance coupler, flexible cord, and wall plug must bear a "T" mark and registration number in accordance with the Japanese Dentori Law. The flexible cord must be Type VCT or VCTF, 3-conductor, 0.75 mm2 conductor size. The wall plug must be a two-pole grounding type with a Japanese Industrial Standard C8303 (15A, 125V) configuration.
Accrediting Agency
EANSW OVE CEBC CSA DEMKO SETI UTE VDE
Country
Italy (1) Japan (3) Norway (1) Sweden (1) Switzerland (1) United Kingdom (1) United States (2)
Accrediting Agency
IMQ JIS NEMKO SEMKO SEV BSI UL
B-2
Power Cord Set Requirements