Text preview for : ph_42r6_343.pdf part of . Various ph 42r6 343 . Various CHINA TV LCD ph_42r6_343.pdf
Back to : ph_42r6_343.pdf | Home
PDP TELEVISION
PH-42R6
Canada
CONTENTS
Safety precautions...................................................................................... 1
Alignment instructions ................................................................................. 3
Working principle analysis of the unit...............................................................6
Block diagram.............................................................................................7
IC block diagram.........................................................................................8
Wiring diagram ......................................................................................... 17
Troubleshooting......................................................................................... 18
Schematic diagram .................................................................................... 24
APPENDIX-A: Main assembly list
APPENDIX-B: Exploded view
Note: This maintenance manual is intended only for the reference of the maintenance people.
Please pay attention to the following points before carrying out the maintenance work.
Safety precautions
Please read the "Points for attention for the Maintenance & Repair of PDP" and "Criterion for
Identifying the Defects on Screen" as below, before inspecting and adjusting the TV set.
1. "Points for attention for the Maintenance & Repair of PDP"
To avoid possible danger, damage or jeopardy to health and to prevent PDP screen from new
damage, the maintenance people must read the following carefully. If they ignore the following
warnings, there will be deathful risks:
1.1 Screens vary from one model to another and therefore not interchangeable. Be sure to use the
same type of screen in the replacement.
1.2 The operation voltage is approximately 350V for PDP module (including screen, driving circuit,
logic circuit and power module). If you want to conduct maintenance work on PDP module when the
set is in normal operation or just after the power is off, you must take proper measures to avoid
electric shock and never have direct contact or touch with the circuitry of the working module or
metal parts. That's because within a short time relatively high voltage still remains on the capacitor
of the driving part even after the power is off. Make sure to begin relevant maintenance operation at
least one minute after the power is off.
1.3 Don't apply on the module any power supply that is higher than the specification. If the power
supply used deviates from the value given in the specification, there might be a possibility of leading
to fire or damage to the module.
1.4 Never have operation or mounting work under unsuitable environment such as areas in the
vicinity of water