Text preview for : HP Ferrite Installation Inst..pdf part of Agilent HP Ferrite Installation Inst. Agilent HP Ferrite Installation Inst..pdf
Back to : HP Ferrite Installation I | Home
About this Manual
We've added this manual to the Agilent website in an effort to help you support
your product. This manual is the best copy we could find; it may be incomplete
or contain dated information. If we find a more recent copy in the future, we will
add it to the Agilent website.
Support for Your Product
Agilent no longer sells or supports this product. Our service centers may be able
to perform calibration if no repair parts are needed, but no other support from
Agilent is available. You will find any other available product information on the
Agilent Test & Measurement website, www.tm.agilent.com.
HP References in this Manual
This manual may contain references to HP or Hewlett-Packard. Please note that
Hewlett-Packard's former test and measurement, semiconductor products and
chemical analysis businesses are now part of Agilent Technologies. We have
made no changes to this manual copy. In other documentation, to reduce
potential confusion, the only change to product numbers and names has been in
the company name prefix: where a product number/name was HP XXXX the
current name/number is now Agilent XXXX. For example, model number
HP8648A is now model number Agilent 8648A.
Ferrites
Ferrites
Ferrites are included in the HP 1660ES-series logic analyzer's
accessory pouch for the HP 1160 Miniature Passive Probes. When
properly installed, the ferrites reduce RFI emissions from the
oscilloscope probes.
In order to ensure compliance of the HP 1660ES-series logic
analyzer's to the CISPR 11 Class A radio frequency interference
(RFI) limits, you must install the ferrite to absorb radio frequency
energy.
NOTE: Adding or removing the ferrite will not affect the normal operation of the
analyzer or oscilloscope.
Ferrite installation instructions
Use the following steps to install the ferrites on the oscilloscope
cables
1 Open the ferrite and place it no more than 1 inch from the
base of the probe cable.
2 Close the ferrite around the cable.
1
Ferrites
*01660-92006*
*01660-92006*
01660-92006
2 1998-January-01