Text preview for : Sony DV-PS360 Bulletins.pdf part of Sony DV-PS360 Bulletins Sony Sony DV-PS360 Bulletins.pdf
Back to : Sony DV-PS360 Bulletins.p | Home
[Sony Service]
Technical Services
Electronic Service Information
Field Problem Reports
------------------------------------------------------------------------
FPR Number:
Submitted by: Tremble, C.
Engineer: TC
Model(s):
DVPS560D
Subject: No part number listed for IC101
Symptom:
Last Update: 2001-05-08
Status: Closed
Customer Description:
Missing Part Number
Solution:
IC101 Part# 9-885-005-99
Technical Description:
No part number is listed for IC1010 in s/m for board SRV940JUC. Schematic
is also incorrect in calling IC101 an - ON3131. A ON3131 is an opto
isolator. IC101 is drawn as a power control FET type integrated circuit.
Part's Information:
P/N Description Reference Board Symptom
-----------------------------------------------------------------------------------
9-885-005-99 SRV940JUC IC101
CONFIDENTIAL CSV-5
Sony Service Company
National Technical Services Service Bulletin
A Division of Sony Electronics Inc.
Park Ridge, New Jersey 07656 Multi-Disc Players
Model: DVP-S360, DVP-S560D, DVP-S570D, DVP-C660, No. 68
DVP-C670D
Subject: PLAYER MAY NOT PLAY CD/DVD OR VCD Date: September 8, 2000
Symptom:
(111A) The DVD player may not play disc. The display may indicate "No Disc "or C:13:00"
Solution: Please remove fuse F402 and replace with 0-ohm resistor on MB board (side B).
Next, exchange resistors R416 and R418. The original values are 150K, change them
both to 82K ohms
REF DESCRIPTION PART NUMBER
F402 CONDUCTOR, CHIP(2012) 1-216-295-11
METL RES 0H 1/10W
R416/ RESISTOR,CHIP 82K 1/16W 1-216-844-11
R418
There are 2 types of MB-bds depending on model. DVPS360, Dvps560D, DVPS570D
(mb-86) DVPC660, DVPC670D is (mb-87)
Reference: HVDK00e007 PRINTED IN USA
Multi-Disc Products Service Bulletin No. 68
.
3. Measure the resistor between Pin # 21 & Pin # 22 of the Flexible Cable,
which is connected with the OPT. (See the figure below.) If the resistor between Pin # 21 & Pin #
22 is below 6 ohms, replace the OPT to the new one.
4. Please do servo adjustment,after replacing components and/or optical.