Text preview for : 8030WF_INSTALLATION.pdf part of LG WD8030 wd8030 service manual
Back to : wd8030.rar | Home
4. INSTALLATION
Before servicing ask troubles of customers Check the adjustment(power supply is 220-240V, remove the transit bolts....) Check the troubles referring to the trouble shooting. Decide service steps referring to disassembly instructions. And then, service and repair. After servicing, operate the appliance whether it works O K or NOT.
STANDARD INSTALLATION
The appliance should be installed as follows.
REMOVE THE TRANSIT BOLTS
Remove the transit bolts (4EA: )with supplied spanner. Keep the transit bolts and spanner for future use.
INSTALL THE APPLIANCE ON FLAT AND FIRM SURFACE
ADJUST THE HORIZONTAL
Turn the leveling feet to set the appliance horizontally.
Low High
The appliance goes up by rotating the feet clockwise. The appliance come down by rotating the feet counter clockwise.
1
8
HOW TO CONNECT INLET HOSE
Check that the rubber packing is inside of the valve connector. Connect the inlet hose firmly to prevent leak.
CONNECT DRAIN HOSE
Make sure that the hose is not twisted.
Avoid submerging the end of the hose.
The drain hose should be placed under 85 CONNECT POWER PLUG
from the floor.
Connect the power plug to the wall outlet.
Avoid connecting several electric devices, It may be the cause of the fire.
9
TEST OPERATION
Preparation for washing.
Press the power button.
Press the START/PAUSE button.
START
PAUSE
Connect the power plug to the outlet. Connect the inlet hose.
In case of Coloreds program.
Check the water heating.
Check automatic reverse turn.
Check the water supply.
Check if the drum rotate to clockwise and counterclockwise.
Check if water is supplied through the detergent dispenser.
Check the drain and spin
Power off
Water removal
800 (1000) 600 (800) no Spin (600) SPIN
Door Open
After power off, press the DOOR OPEN button to check the door open.
If SVC is needed, during check and remove the remaining water by pulling out the hose cap.
Trouble shooting refer to (7.ERROR DISPLAY) Assemble and disassemble refer to (9.Disassembly Instructions)
10