Text preview for : 7jbhdd3.pdf part of panasonic 7jbhdd3 panasonic Audio SA-PTX7EB MD0704019CE doc 7jbhdd3.pdf



Back to : 7jbhdd3.pdf | Home

To cancel restore
Restoring backed up data 1 Press and hold [ ] during restoring.
Restore
This function will restore the backup data that was saved on
This function will pause and the po wer will
your PC to this unit. turn off immediatel y.
Do you want to contin ue?
If the HDD requires service, please wait until the HDD has
Yes No
been repaired before restoring the backup to the HDD.
ENTER


Restoring the backup data to the HDD will reset the
HDD (no tracks on the HDD). If restoring fails, the 2 Press [ ] to select "Yes" and press [ENTER].
content of the HDD will be lost. When restoring the This unit is turned off and the restore is canceled.
backup data, therefore, please exercise the utmost If restore is canceled before completion, all progress up to
caution. the point of cancelation will not be recorded and the HDD
will be completely empty. Restore this unit again later.

Perform "Preparation" and "Settings to check on the PC" as
described on OI page 81. Note
Restore may be canceled if your PC is turned off in an
1 Press [SETUP]. irregular manner or is forced to shut down due to errors. In
2 Press [ ] to select "Other Setup" and press this situation, restore again from the beginning. However,
backups may not restore when the backup data contains
[ENTER].
abnormalities.
3 Press [ ] to select "Maintenance" and press [ ].

4 Press [ ] to select "Backup/Restore" and press
[ENTER].
5 Press [ ] to select "Restore" and press [ENTER].
Restore

PC Name

User Name

Passwo rd

Restore Cancel



ENTER

Cancel




6 Press [ ] to select "PC Name" and press [ENTER].
When the PC name is displayed
The PC name and other information that was used when
previous backups and imports ( OI page 44) were
performed may be displayed. In this case, check the PC
name again, and if necessary, follow the steps below to
make changes.
7 Enter the characters ( OI page 62).
Input the "User Name" and "Password" in steps 6 and 7 in
the same manner.
8 Press [ ] to select Res tore and press
[ENTER].
Restore begins.
A message will be displayed, indicating that restore is
complete. The unit will briefly stay this way, and then it will
turn off automatically shortly after.

To return to the previous screen
Press [RETURN].