Text preview for : Readme.txt part of Tektronix Readme Tektronix TDS7000 TekScope_Opt_App_1.0.10_071-1883-01_063-3914-10 TekScope_Opt_App_1.0.10_071-1883-01_063-3914-10 Applications 07_HT3-1.3 DTG_Pattern_Files Readme.txt
Back to : Readme.txt | Home
HDMI Compliance Test Software(1.3) (DTG Distribution)
Product: TDSHT3v1-3 (DTG Distribution)
Version: 3.3.1
Date : 10th October 2007
================================================================================
What is in this file:
1. System Requirements
2. Installation
3. Contact Tektronix
================================================================================
1. System Requirements
- The HDMI Compliance Test Software(1.3) is compatible with the following
instruments:
Product Firmware-Version
========== ==================
DTG5274 1.0.14
DTG5334 2.0.4
- Disk space requirements:
585Mb of free disk space to install and operate this application.
================================================================================
2. Installing DTG Patterns
The Sink and Cable tests require DTG Patterns on the DTG at -
C:\TekApplications\TDSHT3v-3 sub-folder. Install the DTG Pattern
files on the Data Timing Generator (DTG 5274/DTG 5334).
If the DTG Pattern files are not installed on the DTG hard disk, perform the
following steps to install it from the Optional Applications Software on a
Windows-Based Oscilloscope Compact disc (CD-ROM):
i. If the keyboard is not installed, connect it to the oscilloscope rear panel
(the optional-accessory keyboard plugs into the USB connector).
ii. Power on the DTG to start Windows.
iii. Install the optional applications software CD in the CD-ROM reader
of the DTG.
iv. The autorun utility will start the installation program. If the autorun
utility doesn't start up automatically, browse to the CDROM and
double-click the launch.exe.
v. Click 'HDMI Compliance Test(1.3)'.
vi. Click 'DTG INSTALL'. This will install the DTG Pattern files at -
C:\TekApplications\TDSHT3v1-3 sub-folder on the DTG.
Or if you have downloaded the DTG patterns installables from the Web, then
double-click TDSHT3v1-3_DTG_Distribution.exe to get the pattern files installed
at - C:\TekApplications\TDSHT3v1-3 sub-folder on the DTG.
================================================================================
3. Contact Tektronix
For any assistance or feedback on the TDSHT3v1-3, please send an email to:
- [email protected] or
- [email protected]
---End of File---