Text preview for : Panel_CPT_CLAA260WU09M_0_[DS].pdf part of . Various Panel CPT CLAA260WU09M 0 [DS] . Various LCD Panels Panel_CPT_CLAA260WU09M_0_[DS].pdf
Back to : Panel_CPT_CLAA260WU09M_0_ | Home
Global LCD Panel Exchange Center www.panelook.com
Chunghwa Picture Tubes, Ltd.
Technical Specification
CPT TFT-LCD
CLAA 260WU09M (tentative)
APPROVED BY CHECKED BY PREPARED BY
Prepared by : Design General Division
CHUNGHWA PICTUER TUBES, LTD.
No. 1, Huaying Rd., Sanho Tsun, Lungtan Shiang, Taoyuan, Taiwan, 325, R.O.C.
TEL: +886-3-4805678 FAX: +886-3-4800589
Doc. No: CLAA260WU09M/tentative Issue Date: 2008/12/03
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
CHUNGHWA PICTUER TUBES, LTD.
Doc. No __
TECHNICAL SPECIFICATION Version
Issue Date 2008/12/03
TitleCLAA260WU09M Technical Specification
Table Of Content
NO Table of Content Note
1 OVERVIEW 4
2 ABSOLUTE MAXIMUM RATINGS 5
3 ELECTRICAL CHARACTERISTICS 6
4 INTERFACE PIN CONNECTION 11
5 INTERFACE TIMING 15
6 BLOCK DIAGRAM 21
7 MECHANICAL SPECIFICATION 22
8 OPTICAL CHARACTERISTICS 24
9 RELIABILITY TEST CONDITIONS 27
10 PACKING SPECIFICATION 29
11 DESIGNATION OF LOT MARK 31
12 HANDLING PRECAUTIONS FOR TFT-LCD MODULE 34
ISO Datasheet No: T-3010004-008-F CHUNGHWA PICTUER TUBES, LTD. Page: 2/31
Datasheet Version.: 01
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
CHUNGHWA PICTUER TUBES, LTD.
Doc. No __
TECHNICAL SPECIFICATION Version
Issue Date 2008/12/03
TitleCLAA260WU09M Technical Specification
1. OVERVIEW
CLAA260WU09M is 25.5" color TFT-LCD (Thin Film Transistor Liquid Crystal Display) module
composed of LCD panel, driver ICs, control circuit and backlight. By applying 8 bit digital data (6 bit
+Hi-FRC), 1920x1200, 16.7M-color images are displayed on the 25.5" diagonal screen. Input power
voltage is 5.0V for LCD driving.. General specifications are summarized in the following table:
ITEM SPECIFICATION
Display Area(mm) 550.08(H)x343.8(V)
Number of Pixels 1920(H)x1200(V)
Pixel Pitch(mm) 0.2865(H)x0.2865(V)
Color Pixel Arrangement RGB vertical stripe
Display Mode normally white, TN
Number of Colors 16.7M (6 Bit +Hi-FRC)
Brightness(cd/m^2) 400 cd/m2 (Typ.)(Center point, Lamp current=6 mA)
Viewing Angle 170 / 160 (Typ.)
Surface Treatment Anti-glare
Power consumption(W) 72.5 (Typ.)
Module Size(mm) 582(W)x375.6(H)x41.5(D)(max)
Module Weight(g) 3700(typ)
Backlight Unit CCFL, 6 tubes
ISO Datasheet No: T-3010004-008-F CHUNGHWA PICTUER TUBES, LTD. Page: 3/31
Datasheet Version.: 01
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
CHUNGHWA PICTUER TUBES, LTD.
Doc. No __
TECHNICAL SPECIFICATION Version
Issue Date 2008/12/03
TitleCLAA260WU09M Technical Specification
2. ABSOLUTE MAXIMUM RATINGS
ITEM SYMBOL MIN. MAX. UNIT REMARK
Power Supply Voltage for LCD VCC 0 6 V
Harrison VL 1760 1940 Vrms
Lamp Voltage
Delta VL 1540 1900 Vrms
Harrison ILO 3 8 mArms
Lamp Current *4). 7)
Delta ILO 3 8 mArms
Lamp Frequency FL 40 70 kHz
VESDt -200 200 V
static electricity *5)
VESDc -8000 8000 V
Operation Temperature Top 0 50 *1). 2). 3). 6)
Storage Temperature Tstg -20 60 *1). 2). 3)
Delayed Discharge Time TD -- 1 Sec *8)
[Note]
1).The relative temperature and humidity range are as below sketch, 90%RHMax.(Ta40).
2).The maximum wet bulb temperature 39(Ta40) and without dewing.
3).If you use the product in a environment which over the definition of temperature and humidity too
long to effect the result of eye-aching.
4).The life time of the lamp is related to the current of the lamp, so please according to the description
of the "(b) backlight" on page 7.
5).Test Condition: IEC 1000-4-2
VESDt: Contact discharge to input connector; VESDC: Contact discharge to module
6).If you operate the product in normal temperature range, the center surface of panel should be under
60.
7).When lamp current is out of the absolute maximum range, the life will fall rapidly or shown
unusual sign.
IL min 2mA only for test only, but we can't guarantee the lifetime and performance.
8).Delay lighting testing needs the volt above start voltage Vrms. Before the procedure tube needs
typical lighting for 1 minute and stay in the temperature 25