p06.pdf part of Philips p06 p06.pdf, Philips Monitor CD 2001 Monitor CD 2001 E-MANUALS Philips crt 105e pdf p06.pdf text manual preview

Text preview for : p06.pdf part of Philips p06 Philips Monitor CD 2001 Monitor CD 2001 E-MANUALS Philips crt 105e pdf p06.pdf

Back to : p06.pdf | Home

6 105E CM23 GSIII Mechanical Instructions
9 Go to cover page
0. General

To be able to perform measurements and repairs on the "circuit
boards", these unit should placed in the service position first.

1. Remove the rear cover

- Open two lids with "-" type screwdriver. Refer to fig2 and fig3. lids
- Remove 4 screws with "+" type screwdriver.

2. Video panel

- Remove the metal shielding on rear side of Video panel by
desolder lags of metal shielding.

3. Main panel

- Disconnect the degaussing coil from Main panel.
- Remove the video panel from CRT.
- Remove the "screw" of I/F cable from Main panel.
- Disconnect the CRT ground "1001" from Video panel.
- Disconnect the Hi-Pot cap from CRT.
- Disconnect the yoke wire connector "M401" from Main panel.
- Slide the main panel out of bottom tray.
- Place Main panel in service position as shown in Fig.1.
- Mount Video panel again on CRT. lid
- To connect Hi-Pot cap again.
- To connect "1001" again.
- To connect the yoke wire "M401" again.

Fig.2

screws

screws

Fig. 1

Fig.3

3Back Forward4