Text preview for : 17GLsi Training Manual.pdf part of samsung 17GLI-GLSI 17GLsi Training Manual
Back to : 17GLsi Training Manual.pa | Home
ALIGNMENTS AND ADJUSTMENTS
Dynamic Edge Convergence Use the following procedure to correct minor dynamic (edge) misconvergence. If, after using this procedure, dynamic misconvergence is still greater than the 0.4mm tolerance (around the periphery of the display area), replace the CRT. 1) Make sure the display is not affected by external magnetic fields. 2) Make sure the static convergence is properly adjusted. 3) Strategically place small magnetic strips on the back of the CRT to correct the misconverence. Be. careful not to remove the paper protecting the adhesive on the magnetic strips until you are satisfiedwith their placement and the dynamic convergence. 4) When you are satisfied with the convergence around the edge of the CRT, permanently glue the magnets to the back of the CRt.
_/
WARNING
Do not remover the factory installed wedges. These wedges were installed by the CRT manufacturer and are properly placed for this CRT. Removal may result in damage to the CRT.
-_
254