Text preview for : Panel_SHARP_LK600D3HA19_0_[DS].pdf part of . Various Panel SHARP LK600D3HA19 0 [DS] . Various LCD Panels Panel_SHARP_LK600D3HA19_0_[DS].pdf
Back to : Panel_SHARP_LK600D3HA19_0 | Home
Global LCD Panel Exchange Center www.panelook.com
No. LD-K23453
DATE May. 17. 2011
TECHNICAL LITERATURE
FOR
TFT-LCD Open Cell
MODEL No. LK600D3HA19
The technical literature is subject to change without notice.
So, please contact SHARP or its representative before designing
your product based on this literature.
LIQUID CRYSTAL DISPLAY DIVISION
LARGE LIQUID CRYSTAL DISPLAY GROUP
SHARP CORPORATION
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
RECORDS OF REVISION
MODEL No. : LK600D3HA19
TL No. : LD-K23453
REVISED
SPEC No. DATE PAGE SUMMARY NOTE
No.
LD-K23453 2011.5.17 - - - 1st ISSUE
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
LD-K23453-1
1. Application
This technical literature applies to the color 60.0" TFT-LCD Open Cell LK600D3HA19.
* This technical literature is proprietary products of SHARP CORPORATION ("SHARP") and includes
materials protected under copyright of SHARP. Do not reproduce or cause any third party to reproduce them in
any form or by any means, electronic or mechanical, for any purpose, in whole or in part, without the express
written permission of SHARP.
* In case of using the device for applications such as control and safety equipment for transportation (aircraft,
trains, automobiles, etc.), rescue and security equipment and various safety related equipment which require
higher reliability and safety, take into consideration that appropriate measures such as fail-safe functions and
redundant system design should be taken.
* Do not use the device for equipment that requires an extreme level of reliability, such as aerospace
applications, telecommunication equipment (trunk lines), nuclear power control equipment and medical or other
equipment for life support.
* SHARP assumes no responsibility for any damage resulting from the use of the device that does not comply
with the instructions and the precautions specified in this technical literature.
* Contact and consult with a SHARP sales representative for any questions about this device.
2. Overview
This Open Cell is color active matrix LCD Open Cell incorporating amorphous silicon TFT (Thin Film
Transistor). It is composed of a color TFT-LCD panel, driver ICs and Source PWB.
The following contents can be achieved in using LK0DZ1C0xxx (C-PWB) and LK0DZ1C0xxx (CS-FPC) that
SHARP specifies.
Graphics and texts can be displayed on a 1920 x RGB x 1080 dots panel with one billion colors by using
10bit+LVDS (Low Voltage Differential Signaling) to interface, +12V of DC supply voltages.
And in order to improve the response time of LCD, this module applies the Over Shoot driving (O/S driving)
technology for the control circuit. In the O/S driving technology, signals are being applied to the Liquid Crystal
according to a pre-fixed process as an image signal of the present frame when a difference is found between
image signal of the previous frame and that of the current frame after comparing them.
With combination of these technologies, motion blur can be reduced and clearer display performance can be
realized.
TFT LCD Panel
(1920 x RGB x 1080)
Open Cell
[LK600D3HA19]
Gate Driver
Source Driver
Source PWB (S-PWB)
SS-FPC
CS-FPC
[LK0DZ1C0xxx]
CN101
Control PWB (C-PWB)
[LK0DZ1C0xxx]
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
LD-K23453-2
3. Mechanical Specifications
Parameter Specifications Unit
152.496 (Diagonal) cm
Display size
60.0 (Diagonal) inch
Active area 1329.12(H) x 747.63 (V) mm
1920(H) x 1080(V)
Pixel Format pixel
(1pixel = R + G + B dot)
Pixel pitch 0.69225(H) x 0.69225 (V) mm
Pixel configuration R, G, B vertical stripe
Display mode Normally black
Open Cell Outline Dimensions mm
1364.18(W) x 806.05(H) x 3.5(D)
[Note1]
Mass 4.2 r 0.3 kg
- Front polarizer : Anti Glare, Low Haze
Surface treatment Hard coating: 2H and more
[Note2] - Rear polarizer :
Hard coating less
[Note1] Outline dimensions are shown in P17.
[Note2] With the protection film removed.
4. Open Cell Driving Specifications
4.1. Driving interface of C-PWB SHARP specifies [LK0DZ1C0xxx]
CN1: Power and LVDS data input
- Using connector: FI-RE51S-HF (Japan Aviation Electronics Ind., Ltd.)
- Matching connector : FI-RE51HL, FI-RE51CL (Japan Aviation Electronics Ind., Ltd.) or equivalent
device
- Mating LVDS transmitter: THC63LVD1023 or equivalent device
Pin No. Symbol Function Remark
1 GND
2 Reserved It is required to set non-connection(OPEN)
3 Reserved It is required to set non-connection(OPEN)
4 Reserved It is required to set non-connection(OPEN)
5 Reserved It is required to set non-connection(OPEN)
6 Reserved It is required to set non-connection(OPEN)
7 SELLVDS Select LVDS data order [Note1,2] Pull up : (3.3V)
8 Reserved It is required to set non-connection(OPEN)
9 Reserved It is required to set non-connection(OPEN)
10 Reserved It is required to set non-connection(OPEN)
11 GND
12 AIN0- Aport (-)LVDS CH0 differential data input
13 AIN0+ Aport (+)LVDS CH0 differential data input
14 AIN1- Aport (-)LVDS CH1 differential data input
15 AIN1+ Aport (+)LVDS CH1 differential data input
16 AIN2- Aport (-)LVDS CH2 differential data input
17 AIN2+ Aport (+)LVDS CH2 differential data input
18 GND
19 ACK- Aport LVDS Clock signal(-)
20 ACK+ Aport LVDS Clock signal(+)
21 GND
22 AIN3- Aport (-)LVDS CH3 differential data input
23 AIN3+ Aport (+)LVDS CH3 differential data input
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
LD-K23453-3
24 AIN4- Aport (-)LVDS CH4 differential data input
25 AIN4+ Aport (+)LVDS CH4 differential data input
26 GND
27 GND
28 BIN0- Bport (-)LVDS CH0 differential data input
29 BIN0+ Bport (+)LVDS CH0 differential data input
30 BIN1- Bport (-)LVDS CH1 differential data input
31 BIN1+ Bport (+)LVDS CH1 differential data input
32 BIN2- Bport (-)LVDS CH2 differential data input
33 BIN2+ Bport (+)LVDS CH2 differential data input
34 GND
35 BCK- Bport LVDS Clock signal(-)
36 BCK+ Bport LVDS Clock signal(+)
37 GND
38 BIN3- Bport (-)LVDS CH3 differential data input
39 BIN3+ Bport (+)LVDS CH3 differential data input
40 BIN4- Bport (-)LVDS CH4 differential data input
41 BIN4+ Bport (+)LVDS CH4 differential data input
42 GND
43 GND
44 GND
45 GND
46 GND
47 VCC +12V Power Supply
48 VCC +12V Power Supply
49 VCC +12V Power Supply
50 VCC +12V Power Supply
51 VCC +12V Power Supply
[Note] GND of a liquid crystal panel drive part should be connected with a module chassis.
[Note1] The equivalent circuit figure of the terminal.
3.3V
10kohm
100ohm
Terminal
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
LD-K23453-4
[Note2] LVDS Data order
SELLVDS
L(GND) H(3.3V) or Open
Data
[VESA] [JEIDA]
TA0 R0(LSB) R4
TA1 R1 R5
TA2 R2 R6
TA3 R3 R7
TA4 R4 R8
TA5 R5 R9(MSB)
TA6 G0(LSB) G4
TB0 G1 G5
TB1 G2 G6
TB2 G3 G7
TB3 G4 G8
TB4 G5 G9(MSB)
TB5 B0(LSB) B4
TB6 B1 B5
TC0 B2 B6
TC1 B3 B7
TC2 B4 B8
TC3 B5 B9(MSB)
TC4 NA NA
TC5 NA NA
TC6 DE(*) DE(*)
TD0 R6 R2
TD1 R7 R3
TD2 G6 G2
TD3 G7 G3
TD4 B6 B2
TD5 B7 B3
TD6 N/A N/A
TE0 R8 R0(LSB)
TE1 R9(MSB) R1
TE2 G8 G0(LSB)
TE3 G9(MSB) G1
TE4 B8 B0(LSB)
TE5 B9(MSB) B1
TE6 N/A N/A
NA: Not Available
(*)Since the display position is prescribed by the rise of DE(Display Enable)signal, please do not fix DE
signal during operation at "High".
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
Global LCD Panel Exchange Center www.panelook.com
LD-K23453-5
LVDS_SEL = Low (GND)
1cycle
ACK+, BCK+
ACK