Text preview for : r_nad.pdf part of ricoh r nad ricoh Copiers Aficio350_450 r_nad.pdf
Back to : r_nad.pdf | Home
Technical Bulletin PAGE: 1/14
Reissued: 31-Aug-99
RTB Correction
The items bold italics have been corrected or added.
Model: NAD 30S/30/40 Date: 31-May-98 No: MA230001a
Subject: China/Taiwan Version Information Prepared by: S. Tomoe
From: Technical Service Department.
Classification: Troubleshooting Part information Action required
Mechanical Electrical Service manual revision
Paper path Transmit/receive Retrofit information
Other ( )
The China and Taiwan version are going to be produced from June 1998. This RTB
clarifies the differences between other Ricoh versions and China/Taiwan versions.
Please refer to the attached documents for more detail.
Technical Bulletin PAGE: 2/14
Reissued: 31-Aug-99
Model: NAD30/40 Date: No:
For both versions
3. Installation
3.1 Chinese paper sizes
3.1.1 267mm X 390mm paper
[B]
[A]
A231I542.WMF
1. Remove the paper tray.
2. Remove the side fences (2 screws each) and the end fence.
3. Peel off the backing of the double-sided tape that is attached to the side fence spacer
(t=7.2 mm) [A].
4. Attach the side fence spacer to the side fence as shown (3 spacers for each side
fence).
NOTE: Both edges of the spacer should be aligned with the bottom edge of the fence.
5. Peel off the backing of the double-sided tape that is attached to the end fence spacer
(t=31 mm) [B].
6. Attach the end fence spacer to the end fence as shown.
7. Install the side fences in the 11" position in the paper tray.
8. Install the end fence in the A3 position in the paper tray.
9. Install the paper tray in the machine and enter the UP mode.
10. Select the paper size as follows