Text preview for : 61240-WW-1.pdf part of MAKITA 61240-WW-1 MAKITA 61240-WW-1.pdf
Back to : 61240-WW-1.pdf | Home
TECHNICAL INFORMATION
Subject Introduction of Kerf Block
61240
For Models LS1013
Country As a standard equipment : European countries, Algeria, Reunion
As an optional accessory : All countries
Description With this Kerf block, a workpiece can be cut cleanly without splinters
on its rear side that contacts with Guide rule.
Kerf Block
workpiece Splinter-free Cut
Kerf Block
Kerf Board
1 How to Install:
Install Kerf block complete on Guide rule
with two + Screws as illustrated to the left.
2
Note:
3 This Kerf block is available for splinter-free cut in the workpiece
up to 35mm in height because the height of the Kerf block is 36mm.
Caution:
1) Never use the Kerf block in bevel cuts.
2) A Kerf block must always be used for cutting at ONE miter angle.
3) When cutting at another miter angle, use another Kerf block.
Failure to save these three instructions will break the Kerf block
into chips and cause serious personal injuries.
1. + Screw M4x12 (Part No.251314-2)
2. Kerf Block Comp. (Part No.151917-1)
3. Guide Rule
Interchangeability(I/C)
Item No. Current part Q'ty I/C New part Q'ty Note
Kerf Block Complete
A13 151917-1 1 For European countries
+ Screw M4x12
A14 2 For European countries
251314-2
Kerf Block Set For all countries
F05 1
193051-1 (See Note below.)
Note
Kerf Block Set includes Kerf Block Complete (1pc.) and + Screw M4x12 (2pcs.).
Implementation
Standard equipment : From serial No.87111E (May, 2000)
Optional accessory : Ready to receive your order since May, 2000