Text preview for : Service Bulletin OST-US007.PDF part of DENON Service Bulletin OST-US007 DENON AV Surround Receiver & Amplifier AV Surround Receiver & Amplifier Denon - AVR-5805 & AVC-A1XV Service Bulletin OST-US007.PDF
Back to : Service Bulletin OST-US00 | Home
100 Corporate Drive Mahwah, NJ 07430
Service Bulletin
No. : OST-US007
Date: April 26, 2007
_____________________________________________________________
Model: AVR-5805
Subject: Disassembly Instructions
Symptom: Disassembly instructions for the AVR-5805 DAC Unit and Digital
Unit.
Solution: See the following pages for details:
______________________________________________________________________________________
CONFIDENTIALITY NOTICE:
The information contained in this document is intended for the exclusive use by DENON Authorized Service Centers and their
employees. This document may contain information that is privileged, confidential and may be protected from disclosure under
applicable laws and terms of the DENON Service Agreement. Any distribution, disclosure, dissemination or copying of this
document and the information it contains is prohibited. No responsibility will be accepted by DENON for any damage, injury or loss
resulting from the misuse of the information contained in this document.
Instruction for removal of DIGITAL UNIT ASSY and DAC UNIT ASSY
(1) Remove screws, detach the BOTTOM COVER (Not shown in the figure)
(2) Remove 6 screws from BACK PANEL, and remove FFCs and cables
(3) Remove 4 Card holders, then detach the Rear Plate/Ethernet/IEEE1394 assy unit.
Remove the FFCs and cables
Remove 4 Card holders
Remove 6 screws from BACK PANEL
(4) Remove FFCs and Cables
(5) Remove 2 screws and incline the PWB.
Remove 2 screws
Incline the PWB
Remove the FFCs and Cables
(6) Remove the screw.
(7) Remove each side board to board connector carefully.
Remove the screw
(8) Insert the finger in the space, and lift the PWB gradually.
(Remove the B to B connectors in the reverse side of the PWB)
Lift the PWB gradually
Remove the B to B connectors
in the reverse side of the PWB
(9) Remove the Cables and detach the Digital unit assy.
Remove the Cables
(10) Remove each side board to board connector carefully.
And detach the DAC unit assy.
Instruction for re-assemble DIGITAL UNIT ASSY and DAC UNIT ASSY
(11) Install the DAC unit assy and insert each side board to board connector.
(Insert the hand in the space on both sides, and push the PWB.)
(11) Install the Digital unit assy and insert the cables.
(12) Insert right side B to B connector.
Insert the B to B
Insert the Cables
Connectors.
(13) Confirm from the slot of the back panel, and insert the B to B connector carefully.
(Insert a thin board (like the ruler) from the slot, and push the PWB).
(14) Insert left side B to B connector and confirm each side board to board connector.
(Insert the hand in the space on both sides, and push the PWB.)
Insert the B to B
Connectors.
(15) Insert FFCs and Cables and tighten 2 screws
Tighten 2 screws
Insert the FFCs and Cables
(16) Install the Rear Plate/Ethernet/IEEE1394 assy unit.
(17) Insert 4 Card holders,tighten 6 screws, and insert FFCs and cables
Insert the FFCs and cables
Insert 4 Card holders
Tighten 6 screws
(18) Install BOTTOM COVER ,and tighten screws.