Text preview for : 2K3-007.pdf part of Kyocera 2K3-007 Kyocera Printer FS-6025-6030MFP SERVICEBULLETINS 2K3-007.pdf
Back to : 2K3-007.pdf | Home
Service Bulletin
SB Number: SB 2K3-007 Creation Date: 22/06/2011
Subject: Procedure when replacing the Main board (Error code C0180)
Model: FS-6025MFP/6025MFP(B)/6030MFP, FS-C8020MFP/8025MFP
Contents
The applicable models are not equipped with a Hard disk, therefore some data is saved at the Main board. Perform
the following procedure when replacing the Main board.
1. Perform Maintenance mode U004 to resolve machine number mismatch that appears after replacing the
Main board.
2. Adjust the Scanner image.
2.1. Input the value in the Auto scanner adjustment chart by using Maintenance mode U425.
2.2. Perform Maintenance mode U411 with the Auto scanner adjustment chart.
2.3. Perform [Halftone adjustment] at the System menu.
3. Reactivate the license for optional products, if these where installed.
3.1. Reactivate the ID card authentication kit B.
3.2. Register ID cards again by using Maintenance mode U222.
4. Import exported data from the machine, before replacing the Main board by using Maintenance mode U917.
Please note that exporting and importing of data is also possible by using the KM-Net Viewer.
5. Register the initial User and Fax settings at the System menu or the Command center.
6. Perform the below mentioned Maintenance modes if necessary.
No. Machine related maintenance mode No. Fax related maintenance mode
U250 Checking/clearing the maintenance cycle U603 Setting user data 1
U251 Checking/clearing the maintenance counter U604 Setting user data 2
U253 Switching between double and single counts U610 Setting system 1
U260 Selecting the timing for copy counting U611 Setting system 2
U326 Setting the black line cleaning indication U612 Setting system 3
U341 Specific paper feed location setting for printing function U615 Setting system 6
U343 Switching between duplex/simplex copy mode U625 Setting the transmission system 1
U345 Setting the value for maintenance due indication U695 FAX function customize
U402 Adjusting margins of image printing
U403 Adjusting margins for scanning an original on the contact glass
U404 Adjusting margins for scanning an original from the DP
U407 Adjusting the leading edge registration for memory image printing
U425 Setting the target
U429 Setting the offset for the color balance
U432 Setting the center offset for the exposure
U470 Setting the JPEG compression ratio
Classification Entire stock rework X In-field modification by case No modification necessary
In-field modification at next visit
Field measure Please follow the above mentioned procedure, when replacing the Main board.
Serial numbers of affected machines
Type Serial number
FS-6025MFP/6025MFP(B)/6030MFP, FS-C8020MFP/ Not available, the above mentioned procedure is only for
8025MFP the field measure.
KMIS Service Department, Kyocera Mita Europe Page 1 of 1 B137 / SB 2K3-007