Text preview for : Quantum Lightning LT 365S and LT 540S SCSI Disks.PDF part of Quanta Quantum Lightning LT 365S and LT 540S SCSI Disks Quanta Quantum Lightning LT 365S and LT 540S SCSI Disks.PDF
Back to : Quantum Lightning LT 365S | Home
QUANTUM LIGHTNING LT 365S AND LT 540S 3 1/2" DISK DRIVE
MODEL # FORMATTED NUMBER BITMAP FORMAT ALPHA MICRO
CAPACITY OF LOGICALS SIZE INTERLEAVE PART NUMBER
LT 365S 348MB 11 4058 1 PDB-00436-34
LT 540S 524MB 17 3953 1 PDB-00436-35
LED CONNECTOR
PIN-1 The Product Option (PO) jumper is configured so that parity
checking on the drive can be controlled.
PO Installed = Parity checking enabled
PO Removed = Parity checking disabled
SERIES 90 AND AMOS SCSI-2 COMPUTERS ONLY: Parity
checking must be enabled.
JP1
RESERVED, NO JUMPER INSTALLED
RESERVED, NO JUMPER INSTALLED
P0
A0
A1
A2
JP2
TERMINATORS
SCSI ID 0 SCSI ID 1 SCSI ID 2 SCSI ID 3
A0 A0 A0 A0
RP1 RP2
A1 A1 A1 A1
A2 A2 A2 A2
JP2 JP2 JP2 JP2
SCSI ID 4 SCSI ID 5 SCSI ID 6
A0 A0 A0
PIN-1 A1 A1 A1
A2 A2 A2
DC POWER JP2 JP2 JP2
In order to use the SCSI format program FMTSCZ.LIT on the Quantum drive pictured above, you
must use the following minimum version of the overlay file FMTSCZ.OVR:
FMTSCZ.OVR 1.0(116) or later
MC1219
(See reverse side for more information)
DSS-10509-06, Rev. A00
Page 2
1.0BOOT PROM COMPATIBILITY INFORMATION
THE DISK DRIVE SHIPPED WITH THIS NOTICE HAS THE
FOLLOWING MINIMUM BOOT PROM REQUIREMENTS
FOR AMOS BASED COMPUTERS
STANDARD BOOT PROM AM-172 ROADRUNNER ENHANCED AM-174 ROADRUNNER ENHANCED
SYSTEM TYPE REQUIREMENTS BOOT PROM REQUIREMENTS BOOT PROM REQUIREMENTS
(and available kits) (and available kits) (and available kits)
EAGLE N/A D00 (PDB-00172-90) A00 (PDB-00174-90)
AM-4000 D00 (DWB-00191-10, Rev. A04) 1 N/A N/A
AM-3000 VME 20MHz C00 (PDB-00185-50) N/A N/A
AM-3000 VME 50MHz C00 (PDB-00185-51) N/A N/A
AM-2000M E00 (PDB-00145-50) D00 (PDB-00172-90) A00 (PDB-00174-90)
AM-2000 VME F00 (PDB-00187-00) E00 (PDB-00172-90) B00 (PDB-00174-90)
AM-1600 D00 (PDB-00135-50) D00 (PDB-00172-90) A00 (PDB-00174-90)
AM-1400 (68010) E00 (B0E-00130-00) N/A N/A
AM-1400 (68020) E00 (B0E-00134-00) N/A N/A
AM-1200 E00 (PDB-00178-01) D00 (PDB-00172-90) A00 (PDB-00174-90)
AM-1000 E00 (PDB-00169-51) D00 (PDB-00172-90) A00 (PDB-00174-90)
MC1127
STANDARD BOOT PROM AM-540 ENHANCED
SYSTEM TYPE REQUIREMENTS BOOT PROM REQUIREMENTS
(and available kits) (and available kits)
AM-3000M E00 (PDB-00140-50) E00 (PDB-00140-50)
7/1/94
1 = AM-4000 boot Proms are located on a small PCB (printed circuit board) (DWB-00191-10) that plugs
into the AM-190 board. In the table above, the revision of the boot PROMs is D00 and the revision
of the printed circuit board assembly that contains the boot PROMs is A04. If you have an A03 or
earlier boot PROM PCB assembly, you simply unplug it and replace it with an A04 or later assembly.
N/A = NOT APPLICABLE OR NOT SUPPORTED
= Part numbers highlighted in gray are the only configurations that support Quantum Empire disk
drives 1GB and larger.
The boot PROM revision appearing in bold in each of the columns is the minimum acceptable
revision level applicable to the disk drive shipped with this notice. If you order a boot PROM kit,
you may receive a later revison boot PROM, which is perfectly acceptable.
This drive does not support AM-175 based AM-1500 computers.
DSS-10509-06, Rev. A00