780dvd.pdf part of TOSHIBA 780dvd 780dvd.pdf, TOSHIBA Laptop 780dvd.pdf text manual preview

Text preview for : 780dvd.pdf part of TOSHIBA 780dvd TOSHIBA Laptop 780dvd.pdf

Back to : 780dvd.pdf | Home

Tecra 780CDM / 780DVD Disassembly Overview

The information offered in this section is an overview of the Maintenance Manual, Chapter 4, Replacement
Procedures. If you have any questions or concerns regarding the proper procedure please refer to the Mainte-
nance Manual through the Toshiba Service and Support Website before you proceed.

This section explains how to remove Field
Replaceable Units (FRUs). It may not be neces-
sary to remove all the FRUs in order to replace
one.

The chart is a guide to which FRUs need to be
removed in order to remove others. The section
numbers on the chart refer to the sections in the
Maintenance Manual, Chapter 4.

Always start by removing the battery pack, next,
optional items such as the optional PC card and
optional memory module, then follow the line on
the chart to determine which FRU you must
remove next in order to repair the one you think is
causing the computer to operate improperly.

To remove the battery pack, follow the steps
below.

CAUTION: When handling battery packs, be
careful not to short circuit the terminals. Also
do not drop, hit or otherwise apply impact; do
not scratch or break the casing; and do not
twist or bend the battery pack.
1. Turn off the power to the computer.
Disconnect the AC adapter and all
external cables connected to the
computer.
2. Turn the computer upside down with the
front facing you and push the battery
lock up to unlock it. A red dot shows
when the lock is in the unlock position.
3. Pull out the battery release lever and
slide it to the left to pop the battery up
slightly.
4. Grasp the battery pack and lift it out.
To install the battery pack, follow the steps below.

WARNING: The battery pack is a lithium ion
battery which can explode if not replaced,
used, handled or disposed of properly.
Dispose of the battery as required by local
ordinances or regulations. Use only batteries
recommended by Toshiba as replacements.
NOTE: Check the battery terminals visually.
If they are dirty, wipe them clean with a dry
cloth.
1. Turn off the power to the computer.
Disconnect the AC adapter and all
external cables connected to the
computer.
2. Make sure the battery release lever is
pulled out then carefully insert the new
or recharged battery pack.
3. Place your fingers just above two pins
on the battery pack that fit into the
locking mechanisms in the battery
socket. Push the battery pack down
carefully until it locks into place.
4. Push the battery lock down to secure it.
The red dot will be covered.

Toshiba TRR Page 7 4/00, Tecra
Tecra 780CDM / 780DVD Disassembly Overview, (cont.)

To remove the optional PC card, make sure the
computer is in boot mode, then follow the steps
below.
1. Turn off the power to the computer.
Disconnect the AC adapter and all
external cables connected to the
computer.
2. Remove the battery pack.
3. Open or remove the PC card slot cover.
4. Press in slightly on the eject button for
the upper and/or lower card and the
button will pop out fully.
5. Now, press the button firmly to pop the
PC card out partially.
6. Grasp the PC card and remove it.
7. Close or replace the PC card slot cover.

To install the PC card, follow the steps below.
1. Open or remove the PC card slot cover.
2. Insert the PC card and press gently to
ensure a firm connection.
3. Close the slot cover or replace the
cover with an appropriate one.
4. Install the battery pack.

To remove the SelectBay module, follow the
steps below.
1. Turn off the power to the computer.
Disconnect the AC adapter and all
external cables connected to the
computer.
2. Remove the battery pack.
3. Turn the computer upside down and
slide the SelectBay lock to the unlock
position, shown by a red box.
4. Pull out the release lever.
5. Push the release lever in firmly to pop
the SelectBay module partially out of
the bay.
6. Grasp the module and pull it out.

CAUTION: The SelectBay modules can
become hot with use.
Be careful when removing the module.

Install the SelectBay modules as described
below.
1. Insert the module in the computer and
press until it locks into place.
2. Fold the release lever into the closed
position.
3. Slide the SelectBay lock to the locked
position. The red box should not be
visible.
4. Install the battery pack.

Toshiba TRR Page 8 4/00, Tecra
Tecra 780CDM / 780DVD Disassembly Overview, (cont.)

You can use the SelectBay cover when you do
not need to use a SelectBay module.
1. To install the cover, first remove the
SelectBay module then hold the cover
by the two finger grips and push it into
place until you hear the latches click.
2. To remove the cover, grasp the two
finger grips and pull the cover out.

To disassemble the DVD-ROM drive, follow the
steps below.
1. Remove six M2x3 silver screws and
two M2.5x6 silver screws securing the
frame to the DVD-ROM drive.
2. Remove the connector cover.
3. Remove the metal frame, connector
board, and disconnect the flexible
cable.