Text preview for : CS480_10.pdf part of LG CS480 10 LG Monitor SW44I(480) CS480_10.pdf
Back to : CS480_10.pdf | Home
DISASSEMBLY
1. TILT/SWIVEL REMOVAL 3. TOTAL CHASSIS ASSEMBLY REMOVAL
Set the monitor faces bottom Disconnect P903 (Degaussing pin) and P701
Pressing the latch , carefully remove the (DY pin).
Tilt/swivel by pulling it upward. Remove two screws from the Main Bracket
to separate it from the Front Cabinet.
Main Bracket
2. BACK COVER REMOVAL 4. CRT BOARD ASSEMBLY REMOVAL
Remove four screws from the Back Cover. Remove four pins .
Slide the Back Cover away from the Front Remove CRT earth connector
Cabinet of the monitor. Carefully separate the CRT Board Assembly
from the CRT neck.
Discharge the remaining static electricity by
shorting between the Anode Cap and the CRT
ground.
Disconnect the Anode Cap from the CRT.
CRT Assembly
Anode Cap
-9-
5. BOTTOM BRACKET REMOVAL 6. MAIN BOARD ASSEMBLY REMOVAL
Remove three screws . Remove three screws .
Remove the Bottom Bracket. Remove the screw .
Remove five screws .
Release three latches from the Main Board
Assembly.
Main PCB Assembly
Bottom Bracket
Main Bracket
- 10 -