Text preview for : TP01(02)AZ.pdf part of TOPPOWER TP01AZ,TP02AZ 1W-2W AC-DC CONVERTERS
Back to : TP01(02)AZ.pdf | Home
TP01(02)AZ Series
DESCRIPTION 1W, 2W 3KVAC Isolation Wide Input AC/DC Converters
The rated output power of TP01(02)AZ series is 1W,2W with wide input voltage range, for both AC input and
DC input application. High reliability, Low power consumption, low leakage current 0.1mA, High
isolation.Product safe and reliable,Good EMC performance,EMC And meet the safety specifications of
IEC/EN61000-4CISPR22/EN55022UL62368/EN662368/IEC62368. Widely used in industrial control and
electrical instrumentation, smart home, which do not have high requirement on EMC.
The EMC external circuit must be added if the products need to be applied to EMC harsh environment.
FEATURES
ultra-small size width is only1.5CM , plastic case Universal input voltage range Low Ripple & NoiseOutput protection
Lower power consumption, no-load loss<0.05W Built-in EMI filter circuit RoHS compliant
R
SELECTION GUIDE
Input Voltage Output Efficiency
Part Number (Typ. ) Ripple (mv)
E
VAC VDC VoltageVDC) CurrentmA %
TP01AZ220S05W 85-305 80-400 5 200 68 150
TP01AZ220S09W 85-305 80-400 9 111 70 150
TP01AZ220S12W 85-305 80-400 12 83 71 150
W
TP01AZ220S15W 85-305 80-400 15 67 71 150
TP01AZ220S24W 85-305 80-400 24 42 65 150
TP02AZ220S05W 85-305 80-400 5 400 70 150
O
TP02AZ220S09W 85-305 80-400 9 222 73 150
TP02AZ220S12W 85-305 80-400 12 167 75 150
P
TP02AZ220S15W 85-305 80-400 15 133 75 150
TP02AZ220S24W 85-305 80-400 24 83 77 150
All specifications typical at TA=25°C, nominal input voltage and rated output current unless otherwise specified.
P
INPUT CHARACTERISTICS
Voltage range 85~ 305VAC,80 ~ 400VDC
Input frequency 47 ~ 440Hz
O
Input current (Typ.) 55m A / 115VAC,34m A / 230VAC
Inrush Current (Typ.) 20 A/230 VAC
T
Recommended values for External Fuses 10/1W( Fusible Resistor)
Leakage current ( Typ.) 0.1Ma at 265VAC/50Hz
OUTPUT CHARACTERISTICS
Output Voltage accuracy ±3.0% (±5.0% max
Line regulation ±1.0%
Load regulation ±1.0%
Start rising time( Typ.) 20ms/230VAC 50ms/115VAC at full load
Start holding time( Typ.) 40ms/230VAC 15ms/115VAC at full load
Short circuit protection Over-Load protection , Over-Current protection ,Short circuit protection , Auto recovery
GENERAL CHARACTERISTICS
Operating temperature --40 ~ +80 (50, derating @0.011W/)
Operating humidity 85% .RH max
Storage temperature 40 ~ +85, 10 ~ 95% RH
Temperature coefficient 0.03%/ (0~ 50)
Vibration coefficient 10~500Hz,2G10min./1cycle, 60min.each along X,Y,Z axes
www.gztoppower.com TEL:0086-20-62162688 Email:[email protected] Page1 / 3
TP01(02)AZ Series
SAFETY AND ELECTROMAGNETIC COMPATIBILITY
Safety standard EN60950,EN60601,UL60950
Isolated Voltage I/P-O/P:3000VAC
Isolated resistance I/P-O/P>100M Ohms/500VDC 25 70% RH
Conduction and radiation EN55011, EN55022 (CISPR22) CLASS BSee the application note for details
Electrostatic discharge ( ESD) IEC/EN 61000-4-2 level 4 8kV/15kVSee the application note for details
Radiofrequency radiation immunity(RF) IEC/EN 61000-4-3 See the application note for details
Electrical fast transient(EFT) IEC/EN 61000-4-4 level 4 4kV
Surge IEC/EN 61000-4-5 level 4 2kV
OTHER CHARACTERISTICS
MTBF 200K hrs min. MIL-HDBK-217F(25)
R
Dimension 32*20*15mm
NOTES
E
1.The above data except for special instructions, are measured at TA = 25oC, humidity <75%, input nominal voltage 230Vac and output rated load
2.Ripple & noise are measured in accordance with the link of the application circuit in this manual, using a 300mm twisted pair-wire and 20MHZ bandwidth
3.The power supply is considered a component which will be installed into a final equipment.
The final equipment must be re-confirmed that it still meets EMC directives
W
TYPICAL APPLICATION CIRCUIT
P O
P
Notes
1.The output filter capacitor C5 is electrolytic capacitor, recommend using of high frequency and low resistance of electrolytic capacitors, the capacity and the current
O
flowing-through need refer to the technical specifications provided by the manufacturer. C4 is use to remove high frequency noise.
2.EMC filter used in the dashed box is to meet the higher requirementsif it is used in general applicationsit can be omitted.
T
3. Our company make the filter circuit in the dashed boxwhich can be used with switching power supply
Component
FUSE R NF MOV CX L1 C5 C4 D1
Part No.
TP01AZ220S05W 1000uF/10V P6KE6.8A
TP01AZ220S09W 680uF/16V P6KE16A
TP01AZ220S12W NF is a 680uF/16V P6KE16A
TP01AZ220S15W common mode MOV is CX is the 470uF/25V P6KE20A
inductance, resistor safety 104K/50V
TP01AZ220S24W 10 No 1MH/0. 220uF/35V P6KE33A
value is recommended capacitor (ceramic
/1W connection 5A
TP02AZ220S05W 30mH, value is 104K 1000uF/10V capacitor) P6KE6.8A
TP02AZ220S09W current is 14D471K /275V 680uF/16V P6KE16A
0.2A-0.5A.
TP02AZ220S12W 680uF/16V P6KE16A
TP02AZ220S15W 470uF/25V P6KE20A
TP02AZ220S24W 220uF/35V P6KE33A
www.gztoppower.com TEL:0086-20-62162688 Email:[email protected] Page2 / 3
TP01(02)AZ Series
MECHANICAL DIMENSIONS PIN CONNECTIONS
DIP packaging
Pin Single Output
1 L
2 N
3 +Vo
4 -V0
R
Unit: MM
PIN length 4.MM PIN diameter0.8MM
tolerance of PIN diameter±0.1MM Unmarked tolerances :±0.5MM
SELECTION GUIDE
E
W
TP 02 A Z 220 S 05 W
W:4:1 Wide voltage input range
O
Main (auxiliary) output voltage
S:single output
P
Rated input voltage
Package type
P
AC-DC
Rated output power
Brand name
O
RATING GR
T
www.gztoppower.com TEL:0086-20-62162688 Email:[email protected] Page3 / 3