Text preview for : gp605-12.pdf part of CANON gp605-12 CANON Copiers GP 405 ServBull ServBullGP605 gp605-12.pdf
Back to : gp605-12.pdf | Home
Service Bulletin COPIER
Issued by Canon Europa N.V.
Model : GP605 No.: GP605-012
(FF-T01-K1-000026-01)
DATE: 10.08.99
Location : ADF PICKUP ASSEMBLY
Subject : ADF PICK-UP JAM THAT OCCURS WITH 200G/M2 PAPER
Reason : When an original using a thick and stiff paper is fed from the ADF, the original may strike the edge of
the copyboard glass with the consequence of folding at the leading edge of the original or an
occurrence of a pick-up jam. To overcome this problem, a spring with higher tension has been made
available to the field. And in this connection, a formal engineering drawing change has been made.
Details :
When an original using a thick paper is fed from the ADF, the original may strike the edge of the
copyboard glass with the consequence of folding at the leading edge of the original or an occurrence
of a pick-up jam for the original.
When a thick and stiff original is fed, it can push down the lower guide (for guiding the paper to the
path the paper is to follow) to a position below the edge of the copyboard glass. When that occurs the
original may strike the glass with the consequence of folding at the leading edge of the original or an
occurrence of a pick-up jam for the original. (See Figure 1.)
Standard weight paper
Lower guide
Tension spring Thick original
Copyboard glass
Lower guide
Area where the lower guide is pushed
down and the original strikes the
copyboard glass.
Fig. 1
-1/2-
GP605-012
Tentative Measures: Supply a countermeasure spring for specific cases of users in the field feeding
thick papers.
Permanent measure: An engineering drawing change has been made to increase the pressure of the
spring in retaining the lower guide in place (prevent it from getting pushed
down) against the downward force of the stiff paper.
Servicing : The diameter of the spring increases due to the engineering drawing change, necessitating a change to
the shape of the following parts (4 locations; Parts Catalog FY8-31DV-000, p. 32) as shown in the
Figure below. It is not possible to install the new spring to the ADF without the modification and for
that reason old parts and old part numbers will continue to be in use.
Note: Since the parts other than the springs used in the modified locations are not assigned as
service parts, change in the revision level segment of the parts numbers is not the matter to
become concerned with.
Rear plate
(Rear) Change in the shape
Reversing guide A
Reversing flapper
Change to the shape
Front plate
Tension spring
(New: FS7-2045) Change in the shape
(Front)
Fig. 2
Service Parts :
Inter- P.C.
-- -- -- -- -- -- -- -- --
No. Description Part number Q'ty change-
ability
1 Old SPRING, TENSION FS7-2031-000 10 30-82
No No
New SPRING, TENSION FS7-2045-000 01
-2/2-