Text preview for : LG G8000 3.pdf part of LG G8000 3 LG Mobile Phone LG G8000 LG G8000 3.pdf
Back to : LG G8000 3.pdf | Home
8. DiSASSEMBLY INSTRUCTION
8. DiSASSEMBLY INSTRUCTION
8-1 Disassembly Instruction
1. Remove the battery cover
- push lockers at both end sides and slide down the battery cover.
2
Figure 8-1. Removing Battery Cover
2. Remove the battery pack and screws.
1
Figure 8-2. Removing Screws
- 118 -
8. DiSASSEMBLY INSTRUCTION
3. Detach the rear cover
-use a thin plastic sheet to open the gap between front and rear covers, then detach them carefully
with both hands.
2
1
Figure 8-3. Disassembling Rear Cover
4. Remove the SIM connector and bracket, and detach the camera FPCB from the main PCB
2
1
3
Figure 8-3. Detaching SIM Connector and FPCB
- 119 -
8. DiSASSEMBLY INSTRUCTION
5. First, remove the main PCB and lift the camera out to detach the frame shield.
Then, detach FPCB as shown in the Fig. 8-5.
1 2
3
Figure 8-5. Detaching Main PCB
- 120 -
8. DiSASSEMBLY INSTRUCTION
6. Detach the keypad and mike.
Figure 8-6. Disassembling Keypad and Mike
7. Remove the antenna and window IrDA, and push away the antenna-bushing using a sharp awl.
1
2
3
Figure 8-7. Removing Antenna and Antenna-bushing.
- 121 -
8. DiSASSEMBLY INSTRUCTION
8. Use a pin to remove Cap Screw and remove screws.
Figure8-8. Removing Cap Screws
9. Use a thin plastic sheet to open the gap between the cover folder upper and cover folder lower,
then detach the cover folder upper carefully with both hands
2
1
Figure8-9. Detaching Upper Cover
- 122 -
8. DiSASSEMBLY INSTRUCTION
10. Use a sharp awl to remove the hinge.
Figure8-10. Removing Hinge
11. Detach the front cover from the lower cover.
Figure 8-11. Detaching Front Cover
- 123 -
8. DiSASSEMBLY INSTRUCTION
12. Remove FPCB from the slit of the lower cover.
Figure 8-12. Removing FPCB
13. Detach LCD very carefully and remove FPCB from the connector of LCD Module.
Figure 8-13. Detaching LCD and FPCB
*Note:When you change FPCB, remove 'tape' and 'solder' firstly.
- 124 -
8. DiSASSEMBLY INSTRUCTION
8-2. Assembly Note
14. First, insert the camera into the main FPCB before assembling them.
2
1
3
Figure 8-14. Assembling Camera Main PCB
15. When placing the main PCB on the frame shield, push the center of it not to override the top
button.
Figure 8-15. Assembling Main PCB
- 125 -