Text preview for : RXA3010_FIRMWARE.pdf part of Yamaha RXA3010 FIRMWARE Yamaha RX RX-A3010 & V3071 RXA3010_FIRMWARE.pdf
Back to : RXA3010_FIRMWARE.pdf | Home
RX-A3010/RX-V3071
UPDATING FIRMWARE /
When the following parts are replaced, the firmware must
RX-A3010/RX-V3071
be updated to the latest version.
DIGITAL1 P.C.B.
DIGITAL2 P.C.B.
FPGA Flash ROM: IC82 on DIGITAL1 P.C.B.
NETWORK Flash ROM: IC904 on DIGITAL1 P.C.B.
DSP1 (TI) Flash ROM: IC923 on DIGITAL1 P.C.B.
DSP2 (TI) Flash ROM: IC518 on DIGITAL2 P.C.B.
Confirmation of firmware version and checksum
Before and after updating the firmware, check the
firmware version and checksum by using the self-
diagnostic function menu.
Start up the self-diagnostic function and select "S4.
ROM VERSION/CHECKSUM" menu.
Using the sub-menu, have the firmware version and
checksum displayed, and note them down.
(See "SELF-DIAGNOSTIC FUNCTION")
* When the firmware version is different from
written one after updating, perform the updating
procedure again from the beginning.
Initializing the back-up IC
(EEPROM: IC83 on DIGITAL1 P.C.B.)
After updating the firmware, the back-up IC MUST
be initialized by the following procedure to store the
setting information (soundfield parameters, system
memory and tuner presetting, etc.) properly.
Start up the self-diagnostic function and select "S3.
FACTORY PRESET" menu. (See "SELF-DIAGNOSTIC
FUNCTION")
Select "PRESET RSRV", press the "MAIN ZONE "
key to turn off the power once and turn on the power
again. Then the back-up IC is initialized.
Required Tools