Text preview for : 4712.pdf part of Braun Oral Line Outline and explosion device, service manual and catalog
Back to : Braun_Oral_Line_Carioquen | Home
Service Documentation Braun Oral-B Plaque Control Ultra
Market Release 8/98
D 6011
4712
4712
BINC Rev: 8/98 BAG Rev: 5/98
Service Documentation
Exploded Drawing 4712
4712 - 2
BINC Rev: 8/98 BAG Rev: 5/98
Service Documentation
Spare Parts List 4712 Part Description
Handle Brush Trickle charger basic Wall attachment
Pos. No.
1 2 3 4
Part Number
4712637 EB 15 4728622 4728052
4712 - 3
BINC Rev: 8/98 BAG Rev: 5/98
Service Documentation
Service Information 4712
Technical Data Voltage: Frequency: Power input: Appliance: 100 - 130 V 50 - 60 c/s approx. 1 Watts Plastic heat sealed. 2.4 V-DC-motor. The transmission of power follows by way of gear train with excenter to the shaft of the brush. 2 built-in batteries, which can be recharged by inductive continuous operating charger (without contact). It compensates the loss of charge in the daily use. Continuous charging. No danger of overloading. Multituft Oscillating brush movements 2800/min. approx. 60° Pressure switch watertight. Length without brush 17.5 cm, diameter 2.9 cm Height 8.4 cm, length 4.1 cm, width 8.6 cm. approx. 35 minutes when unit was fully charged.
Power supply:
Charger, continuous operation: Brushes: Brush function: Angle of oscillation: Switch: Dimensions of the unit: Dimensions of the charger: Operating time:
Preserving the rechargeable batteries (NiCd) To maximize the capacity and life of the rechargeable batteries, they should be fully charged for 16 hrs. before first use and then fully discharged by normal use. Then recharge to full capacity again. The discharging/charging procedure should be done at least every 6 months.
4712 - 4
BINC Rev: 8/98 BAG Rev: 5/98
Service Documentation
Service Information 4712
Preserving the rechargeable batteries (NiMH) To maximize the capacity and life of the rechargeable batteries, they should be fully charged for 32 hrs. before first use and then fully discharged by normal use. Then recharge to full capacity again. The discharging/charging procedure should be done at least every 6 months. Cell-Pack Recycling At the end of the time-of-use of this product, for environmental protection, the battery cell pack must be correctly recycled. For this purpose, the following steps are necessary: · Fit the slits on the bottom cap of the rechargeable power unit onto the protruding rim on the bottom of the recharger. Turn the rechargeable power unit approximately 60° in the direction of the arrow (anti-clockwise) as far as it will go. (see illustration) By applying pressure to the motor shaft, push cell pack with motor assembly out of the housing and tear off both thin connecting wires. Break off cell pack with PCB from motor and remove the remaining part of the PCB from the cell pack.
· ·
·
Remove the battery and dispose of according to the local environmental regulations. The cells must never be thrown into fire or flame.
Attention This product contains nickel cadmium or nickel hydride cells. In the interest of protecting the environment, please do not dispose of the cells in the household waste at the end of their useful life. Disposal can take place at appropriate collection sites provided in your country. This product conforms to the EMC requirements as laid down by Council Directive 89/336/EEC. 4712 - 5